Panel Installation - Airwell CDMX-035N-09M25 Technical Manual

11. Panel Installation

11.1 Panel Installation of Super-slim Cassette
11.1.1
Remove the front grille
1.Push one side of the grille screw cover then remove the
grid screw.
2. Push both of the tabs towards the middle
simultaneously to unlock the hook on the grille.
3. Hold the grille at a 45° angle, lift it up slightly and
detach it from the main body
Remove the grid screws
Grille switch
Grille screw cover
3.3.2 Remove the installation covers at the four
corners by sliding them outwards.
3.3.3 Install the panel
1. Align the front panel to the main body, taking into
account the position of the piping and drain sides. Hang
the four latches of the decorative panel to the hooks of
the indoor unit. Tighten the panel hook screws evenly at
the four corners.
Note: Tighten the screws until the thickness of the sponge
between the main body and the panel reduces to 4-6mm
(0.2-0.3"). The edge of the panel should be in contact
with the ceiling well.
 Page 140 
2. Adjust the panel by turning it to the direction of arrow
shown in figure below so that the ceiling opening is
completely covered.
Ceiling
Panel side sponge
Panel
Panel foam 1
NOTE: If the height of the indoor unit needs to be
45°
adjusted, you can do so through the openings at the
panel's four corners. Make sure that the internal wiring
and drainpipe are not affected by this adjustment.
Water condensation
Failure to tighten screws can cause water leakage.
Gap not allowed
If the unit is not hung correctly and a gap exists, the unit's
height must be adjusted to ensure proper function. The
Into the wind
Main body
Baffle
Out of the wind
1
Loosen upper nut
2 Adjust lower nut
Outlet foam
Panel foam 2