Table of Contents
Advertisement
HOW TO USE
To Make Espresso:
Always switch power to the "O (Off)" position and remove the plug from
the outlet before filling the tank with water. Ensure water will not
overflow the water tank.
1. Turn the 'Tank Cover (for Espresso)' in a counter-clockwise motion (see figure 1) to
open. Using the 'Espresso Carafe, fill the tank with the adequate amount of water.
See the "Coffee/Water Measurement Table" on page 9 for proper water amounts.
2. Turn the 'Tank Cover (for Espresso)' clockwise until it has tightly closed (see
figure D). Turn the 'Steam Knob' clockwise until it becomes tight (see Figure E).
3. Place the 'Espresso Filter' into the 'Brew Basket'. Using the 'Measurement Spoon',
fill with the desired amount of ground coffee; removing any excess ground coffee
from the top rim. Use the 'Tamper' to pack the ground coffee down tightly (refer to
the "Coffee/Water Measurement Table" on page 9 for a coffee amount guideline).
4. Affix the 'Brew Basket' to the coffee maker by:
a)
Aligning the mouth of the 'Brew Basket' with the espresso spout.
b)
Turning the handle of the 'Brew Basket' from a left facing position counter-
clockwise until it is located in the central position of the unit.
c)
Ensure that the 'Brew Basket' is firmly secured.
5. Turn the 'Flavor Control Knob' to the needed position: "Light" or "Strong" (see figure
F ) depending upon preference. The "Steam" position is intended for cappuccino (see
"To Make Cappuccino" on page 8).
Close
Open
Strong
Figure D
Do not operate the espresso function with the 'Flavor Control Knob' in
the "Steam" position. The "Steam" position is only intended for frothing
milk for cappuccino.
CONTINUED ON NEXT PAGE
NOTE
Steam
Strength
Off
Figure F
Figure E
NOTE
www.Ginnys.com
6
To Make Espresso (continued):
6. Place the 'Espresso Carafe' on the 'Drip Tray' and ensure the lid aligns with the
spout of the 'Brew Basket'. Press the 'Switch (for Espresso)' to the "— (On)" position.
The 'Switch Indicator Light' will illuminate. Brewed espresso will begin to flow in
approximately 3 minutes.
Do not detach the 'Filter Holder' during the brewing cycle
7. Once brewing has completed, press the 'Switch (for Espresso)' to the "O(Off)"
position by hand. Remove the 'Espresso Carafe' from the 'Drip Tray' and dispense
coffee into cups to serve.
8. Before removing the 'Brew Basket', pressure in the 'Water Tank (for Espresso)' must
be released. To do so follow these steps:
a)
Turn the 'Steam Knob' slowly counter-clockwise. Steam will escape from the
'Steam Pipe'. Place a towel under the 'Steam Pipe' to soak up any water and
protect the surface the 3-in-1 Coffee and Espresso Machine is placed upon.
b)
Once pressure has been completely released, and the 'Brew Basket' has
cooled, remove it by turning clockwise.
9. Firmly hold down the 'Retaining Clip' with your thumb (see Figure G). Then tilt the
'Brew Basket' over a waste receptacle, tapping it to remove all contents (see
Figure H). Wash the 'Brew Basket' and 'Espresso Filter' in warm, soapy water prior
to reassembly.
Strong
10. Return the 'Retaining Clip' to the original position before reattaching the
'Brew Basket'.
HOW TO USE
NOTE
Hold down 'Retaining Clip'
Figure G
www.Ginnys.com
7
Figure H
Advertisement
Table of Contents
