Ginnys 660741 Instruction Manual page 7

HOW TO USE
To Make Cappuccino:
Adding frothing milk to a cup of espresso produces this delicious drink.
1. Prepare espresso according to steps 1-6 in the "How to Make Espresso" section
beginning on page 6 (include an additional cup of water, according to the 'Espresso
Carafe',. to ensure there will be enough steam to froth milk).
2. Turn the 'Switch (for Espresso)' to the "O (Off)" position while dispensing the
espresso.
2. Ensure the 'Steam Knob' is turned off.
3. Set the 'Switch (for Espresso)' to the "— (On)" position. Wait approximately 3
minutes to allow enough steam to be produced.
4. Fill a mug with the desired amount of milk (whole or low-fat) for each cappuccino to
be prepared. Place the mug under the 'Steam Pipe', ensuring the 'Nozzle' of the
'Steam Pipe' is immersed in the milk. For best frothing results, place the 'Nozzle'
just below the milk's surface.
Make sure the mug for milk is large enough to accommodate at least
one and a half times the volume of milk
5. Turn the 'Steam Knob' counter-clockwise slowly. The milk will quickly begin to froth
with the released steam. Once the volume of frothing milk has grown to the desired
amount, turn the 'Steam Knob' clockwise to stop the release of steam.
6. Mix espresso with the frothed milk, stirring with a spoon. Add chocolate powder or
cinnamon, if desired.
7. Dispense remaining steam through the 'Steam Pipe' by turning the 'Steam Knob'
counter-clockwise. Place a towel under the 'Steam Pipe' to collect any excess water
and to protect the surface that the 3-in-1 Coffee and Espresso Machine is resting
upon.
www.Ginnys.com
NOTE
8
HOW TO USE
To Make Drip Coffee (Continued):
3. Place the 'Filter Basket' into the the 3-in-1 Coffee and Espresso Machine. The 'Filter
Basket' must be inserted correctly for proper operation. Place the 'Filter Basket' in
with its handle up (see Figure A below). Be sure the locking hinge is inserted
correctly (see Figure B), then close the 'Filter Basket' handle (see Figure C). This will
lock the 'Filter Basket' into place and ensure proper operation.
Figure A
4. Add the desired amount of ground coffee to the 'Permanent Filter'. Use the
'Measuring Spoon' to measure the amount of ground coffee to use. See the
"Coffee/Water Measurement Table" on page 9.
5. Close the 'Tank Cover (for Coffee)'. Place the 'Coffee Carafe' onto the 'Keep Warm
Plate'.
6. Plug the power cord into an available outlet. Press the 'Switch (for Coffee)' to the "—
(On)" position. The 'Switch Indicator Light' will illuminate and the appliance will begin
operation. Brewing may be stopped at anytime by pressing the 'Switch (for Coffee)'
to the "O (Off)" position. Brewing will then recommence once the 'Switch (for Coffee)'
has been switched back to the "— (On)" position.
The 'Coffee Carafe' can be removed at anytime during the brewing
process to serve, but it must be placed back onto the 'Keep Warm
Plate' immediately.
7. Once brewing has completed, the coffee maker will automatically switch to 'Keep
Warm'. It will remain on 'Keep Warm' until the appliance has been removed from the
power source.
www.Ginnys.com
Figure B
Figure C
NOTE
5