Chacon 34038 User Manual page 48

3. Mode of use
Two methods:
a) Associating the remote control with a control
panel with keypad: You just have to make the
pre-registered code in order to activate or deacti-
vate the alarm. (see corresponding manual)
b) Associating the remote control with a classic
control panel: activate and deactivate the alarm
using the «on» and «off» buttons on the remote
control (see corresponding manual)
NOTE: This remote control is compatible with the
entire range. You can therefore combine it with any
device while ensuring that you have at least one
central alarm unit (motion detector with or without
code, opening detector with code)
4. Reset pairing
In order to reset your entire alarm, remove the
batteries from your device. Then press and hold
the learning button of your central unit. When you
reinsert the batteries, you will hear two «beeps»
indicating that the reset was successful.
EN