Page 1
Untitled Document Upgrading the COOLPIX775 Firmware — Macintosh — Thank you for choosing a Nikon product. This guide describes how to upgrade the camera firmware for the COOLPIX775. Get ready To upgrade the firmware for the COOLPIX775, you will need: •...
Page 2
Untitled Document Press and hold the MENU button while turning the camera on. “E775 V” will be displayed in the monitor, followed by the version number of the current camera firmware. If the monitor shows “E775 V1.3U,” the current camera firmware is version 1.3.
The firmware can be copied to the camera memory card either by connecting the computer directly to the COOLPIX775 using the USB cable, or by removing the memory card from the camera and inserting it in a CompactFlash card reader.
Page 4
UC-E2 USB cable Turn the camera on. If Nikon View has been installed on the computer, Nikon Transfer will start automatically and display the message, “There is no selected transfer image in the camera or on the card.” Click OK to exit Nikon Transfer.
Page 5
Insert the formatted memory card into the card reader. If Nikon View has been installed on the computer, Nikon Transfer will start automatically and display the message, “There is no selected transfer image in the camera or on the card.” Click OK to exit Nikon Transfer.
Page 6
Disconnect the card reader. For more information, see the documentation provided with the card reader. Update the camera firmware Should any of the following occur during the update, the COOLPIX775 could become inoperable: • The memory card is removed from the camera •...
Page 7
COOLPIX775.” If “E775 V1.4U” is displayed in the monitor, the update was successful. If the update was not successful, contact a Nikon service representative. Format the memory card. • Insert the memory card used to update the camera firmware. • For information on formatting memory cards, see the Nikon...