Table of Contents
Advertisement
Installation
• Switch on power and check the green light on alarm cover. It should glow when
mains power is switched on indicating that the smoke alarm is properly connected to
the mounting base.
• If required, secure Tamper Proof Locking Screw (supplied) to smoke alarm.
• Test alarm by pressing Test button
until the alarm sounds.
Figure 1: Please insert the smoke
alarm's latch into it's base horizontally.
Figure 3: Use a screwdriver to loosen the
screw and then press the button to open
12
the battery compartment.
Figure 2: Lock the smoke alarm base along with
the spindle. then tighten the screws with a screwdriver
(screws (PA3*8) are in the accessory bag).
Figure 4: Please push in the direction
of the arrow firmly and the smoke
alarm can be released from the base.
Advertisement
Table of Contents
