Life 39.LED07600 User Manual

Rechargeable light 60 led

Advertisement

Quick Links

ATTENZIONE/WARNING
RISCHIO DI SCARICHE ELETTRICHE
RISCHIO DI SCARICHE ELETTRICHE
ELECTRIC SHOCK HAZARD
ELECTRIC SHOCK HAZARD
NON APRIRE / DON'T OPEN
NON APRIRE / DON'T OPEN
ATTENZIONE: PER PREVENIRE RISCHI DI SCARICHE
ATTENZIONE: per prevenire rischi di scariche elettriche e pericoli
ELETTRICHE E PERICOLI D'INCENDIO.
d'incendio, non esporre questo prodotto alla pioggia, all'acqua in genere,
all'umiditá e non rimuovere il coperchio.
RIVOLGERSI ESCLUSIVAMENTE A PERSONALE TECNICO
questa parte non contiene componenti di manutenzione.
QUALIFICATO.
USARE SOLO IN INTERNI
ATTENTION:
RIVOLGERSI ESCLUSIVAMENTE A PERSONALE TECNICO
QUALIFICATO.
TO PREVENT FIRE OR ELECTRICAL SHOCK HAZARD
REFER TO QUALIFIED PERSONNEL
WARNING: To prevent fire or electrical shock hazard, don't expose this
item to rain, to water in general, to humidity and don't remove cover.
this section does not contain components of maintenance.
INTERNAL USE ONLY
REFER TO QUALIFIED PERSONNEL.
MANUALE UTENTE /USER MANUAL
LAMPADA RICARICABILE 60 LED
RECHARGEABLE LIGHT 60 LED
Avvisi importanti / Warnings
1. Per la vostra sicurezza leggere attentamente le istruzioni prima di utilizzare
Importato da
LIFE ELECTRONICS S.p.A.
il prodotto.
Via Raffaele Leone 3, 95018 Riposto (CT)
2. Assicurarsi che il prodotto sia correttamente alimentato.
www.life-electronics.com
Made in CHINA
3. Caricare la batteria interna per 24 ore al primo utilizzo.
4. Per assicurare una maggiore durata alla batteria si consiglia di ricaricare la
lampada appena la luce è meno luminosa. Non utilizzare la lampada quando la
batteria è scarica.
5. Se si utilizza la lampada per 3 ore consecutive, la batteria deve essere
ricaricata per 24 ore.
6. Non caricare la batteria quando la temperatura è inferiore a 0°C o superiore a
40°C. L'efficienza della batteria potrebbe essere compromessa.
7. Tenere la lampada lontana da liquidi, fonti di calore, non esporre alla luce
diretta del sole.
8. Contattare un tecnico qualificato per eventuali riparazioni.
9. Resistente agli schizzi, ma non è Waterproof, quindi non immergere in liquidi.
1. For your own safety, read the instructions carefully before using the product.
2. Make sure the product is properly powered.
3. Charge the internal battery for 24 hours before initial use.
4. To ensure longer battery life it is recommended to recharge the light as soon
as the light is less bright. Don't use light when battery is low.
5. If you use light for 3 hours continuously, the battery must be recharged for 24
hours.
6. Not charge the battery when the temperature is below 0 °C or above 40 ° C.
The efficiency of the battery may be compromised.
7. Keep the light away from liquids, heat sources and direct sunlight.
8. Contact a qualified technician for repair.
9. This unit is Splash Resistant and NOT Waterproof so do not immerse it in
water.
Ricarica batteria / Battery charging
1. Inserire il cavetto di alimentazione nella presa di rete.
2. L'indicatore led verde si accenderà per indicare che la lampada sta iniziando a caricarsi.
Potrebbe verificarsi un normale surriscaldamento della lampada durante la carica
1. Plug the power cable into the wall outlet.
2. The green LED indicator will light up to indicate that the lamp is charging.
There may be a normal light overheat while charging.
39.LED07600

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 39.LED07600 and is the answer not in the manual?

Questions and answers

Summary of Contents for Life 39.LED07600

  • Page 1 2. Make sure the product is properly powered. 3. Charge the internal battery for 24 hours before initial use. 4. To ensure longer battery life it is recommended to recharge the light as soon as the light is less bright. Don’t use light when battery is low.
  • Page 2 Desoldering positive and negative wire and remove the battery • Select the brightness level “Max” or “Min” and connect the light to the mains and LED green light will 5. Installare una nuova batteria 4V 1,8 Ah (cod.Life 74.1004018 ) fissandola con l’adesivo in be on.

Table of Contents