Sony MD Walkman MZ-R55 Operating Instructions Manual page 62

zAdditional information
Messages
If the recorder cannot carry out an
operation, error messages may flash in the
display window as follows.
BLANK DISC :
You tried to play an MD with no
recording on it.
DISC ERR :
The recorder cannot read the MD (it is
scratched or dirty). Reinsert the MD. If
the same message still appears, replace
the MD.
DISC FULL :
There is no more space to record on the
MD (less than 12 seconds available).
Data Save:
The MD player is recording information
(sounds) from the memory to the disk.
Wait until this process is completed. Do
not expose the player to any physical
shock, nor disrupt power supply.
Toc Edit :
The MD player is recording information
(track start and end position) from the
memory to the disk. Wait until this
process is completed. Do not expose the
player to physical shock, nor disrupt
power supply.
BUSY :
You tried to operate the recorder while it
was accessing the recorded data. Wait
until the message goes out (in rare cases,
it may take about a minute).
NAME FULL :
You tried to enter more than 200 letters to
label a single track or disc.
You tried to enter a total of more than
1700 letters for track or disc names during
playback or stop.
You tried to enter a total of more than 500
letters for track or disc names during a
single recording.
Hi DC in :
The power supply is higher than
required. Use the recommended power
sources.
62
HOLD :
You tried to operate the recorder with the
HOLD switch slid in the direction of the
arrow. Slide back the switch.
LOW BATT :
The rechargeable battery or dry batteries
are weak. Charge the rechargeable
battery or replace the dry batteries.
MEM OVER :
You started recording when there is no
indication in the display, with the
recorder receiving continuous vibration.
Put the recorder on the stable place and
start recording again.
NO COPY :
You tried to make a copy from a disc that
is protected by the Serial Copy
Management System. You cannot make
copies from a digitally connected source
which was itself recorded using the
digital connection. Use the analog
connection instead.
NO DISC :
You tried to play or record with no disc in
the recorder.
NO SIGNAL :
The recorder could not detect digital
input signals. Make sure that the source is
connected firmly. If the message appears
while recording, press p to end
recording.
P/B ONLY :
You tried to record or edit on a
premastered MD (P/B means playback).
PROTECTED :
You tried to record or edit on an MD with
its tab in the record-protect position.
SORRY :
You tried to erase a track mark while
playing the MD or at the beginning of the
first track.
You tried to erase a track mark to
combine tracks the recorder cannot
combine. 1)
You tired to press DIGITAL MEGA BASS
when the LINE OUT jack is plugged in.
You tried to press p or T MARK during
synchro-recording.
TEMP OVER :
Heat has built up in the recorder. Wait
until the recorder cools down.
TR FULL:
You tried to record more than 254 tracks.