Advertisement
Unpacking and Setup
1. Remove the product and all packing materials from the carton.
2. It is a good idea to save the packing materials in case the unit
needs to be returned for service. If you do dispose of the packing
materials, please do so properly.
3. Remove any feature labels, fact tags, or clear protective films
from the front or top of the unit, if applicable. Do not remove
any warning labels from the back or bottom of the unit.
4. The unit should be placed on a level surface, away from direct
sunlight, and away from the sources of excess dust, dirt, heat,
water, moisture, vibration, and strong magnetic fields.
5. Protect your furniture when placing the unit on natural wood or
wood with a lacquered or coated finish. A cloth or other protective
material should be placed between the unit and the furniture.
Figure Installation
³
Align arrow marks on the lid top and the figure bottom and then
insert the figure into the lid.
Turn the figure to the right to lock the figure in place.
Getting Started
Installing the Batteries
NOTE: This unit can operate on either battery or optional AC
adaptor. While the AC adaptor is plugged in, the batteries will not
be used.
ATTENTION: AC adaptor and batteries should only be installed
by an adult.
³ Use a Phillips screwdriver to open the battery compartment
door located on the bottom of the unit.
Install 6 C size batteries, making sure that the + and –
polarities match the diagram printed inside the battery
compartment.
Close the battery compartment door and tighten the battery
door screw. Do not over-tighten.
For the Best Possible Performance
• We recommend the use of alkaline batteries for longer life.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries.
• Batteries are to be inserted with correct polarity.
• Remove exhausted batteries from the unit.
• Do not attempt to recharge non-rechargeable batteries.
• Remove the rechargeable batteries from the unit before charging.
• The supply terminals are not to be short-circuited.
• Batteries should be removed if the item will not be used for an
extended period of time, such as a month or longer, to prevent
battery leakage or damage.
• Rechargeable batteries should only be charged under adult
supervision.
• Only batteries of the same or equivalent type as recommended
are to be used
Figure Installation
³
align arrow
marks on the
lid top and the
figure bottom
Battery Installation
³
Music On/Off Button
Lift lid to open
CD door
Skip/Search
Backward Button
Forward Button
Repeat Button
Volume Knob:
Turn UP
Turn DOWN
On/Off Switch
VOLUME
OFF
1 2
CD Track Display
Jewelry Tray
Back View
Optional AC Adaptor Installation
NOTE: The AC adaptor should only be connected by an adult.
• Connect a DC 9V 1.5A, center positive AC adaptor (not included)
into the DC Jack located on the back of the unit, then plug the
AC adaptor into an outlet.
Skip/Search
Listening to Compact Discs
Stop Button
1. Slide the On/Off Switch to On to turn on the unit.
Play/Pause Button
2. Lift the
player's lid to access the mirror and jewelry tray.
built-in music will begin to play. Press the small jewelled Music
On/Off Button as needed to stop or start the built-in music.
3. Remove the jewelry tray to access the CD compartment. Place
a CD into the CD compartment, with the CD's label facing up,
and then close the CD door. The CD will spin for a few seconds,
and the display will show the number of tracks on the CD.
4. Press the
track will begin playing.
5. Press the
again to resume playing the CD.
6. Press the
Press the
is currently playing. Press the
to the previous track.
7. Rotate the Volume Knob to adjust the volume level (LEFT to
raise volume, RIGHT to lower it).
8. To stop playing a CD, press the
9. To turn the power off, slide the On/Off Switch to Off.
Using the Repeat Function
1. Press the
will appear on the display.
2. Press the
ALL" will appear on the display, indicating that this function has
Mirror
been activated. When the CD has ended, it will start over again
from the beginning.
3. To cancel the repeat functions, press the
indicators appear on the display.
Performing a High-Speed Music Search
Press and hold the
passages within a track. When the passage is found, release the
button. The high-speed search can only be performed while a track
is playing.
DC Jack
Headphone Jack
Using Optional Headphones
Plug your headphones (not included) into the Headphone Jack for
private listening. The speakers will not emit sound when headphones
are plugged into the jack.
Questions or Comments
• For questions or comments regarding this or other KIDdesigns
products, please call our toll-free number: 1-888-TOP-TOYS
Also visit our website: www.kiddesigns.com
If problems persist, please do not attempt to repair unit; see
warranty for factory service.
The
Button. The display will show "01 ", and the first
Button to pause the CD. Press the
button
Button to skip to the beginning of the next track.
Button to return to the beginning of the track that
Button again to skip backwards
Button.
Button once to repeat the current track. "REPEAT"
Button again to repeat the entire CD. "REPEAT
Button until no
Button or
Button to search for specific
Advertisement
