PictBridge compliant printer
A connection cannot be established.
The camera cannot be connected directly to a printer that is not compliant with the PictBridge
•
standard. Consult the printer manufacturer as to whether the printer is compliant with
PictBridge or not.
Check that the printer is turned on and can be connected to the camera.
•
Set [USB Connect] to [PictBridge] in the
•
Disconnect and connect the USB cable again. If an error message is indicated on the printer,
•
refer to the operating instructions supplied with the printer.
Cannot print images.
Check that the camera and the printer are properly connected using the USB cable.
•
Turn on the printer. For further information, refer to the operating instructions supplied with
•
it.
If you select [Exit] during printing, images may not print. Disconnect and connect the USB
•
cable again. If you still cannot print your images, disconnect the USB cable, turn the printer
off and then on, then connect the USB cable again.
•
Movies cannot be printed.
Images shot using cameras other than this camera or images modified with a computer may
•
not be printed.
Printing is canceled.
You disconnected the USB cable before the
•
disappears.
Cannot insert the date or print images in the index mode.
•
The printer does not provide these functions. Consult the printer manufacturer as to whether
the printer provides these functions or not.
The date may not be inserted in the index mode depending on the printer. Consult the printer
•
manufacturer.
"---- -- --" is printed on the date-inserted part of the image.
Images that do not have the recording data cannot be printed with the date inserted. Set [Date]
•
to [Off] and print the image again (page 71).
Cannot select the print size.
Consult the printer manufacturer as to whether the printer can provide the desired size.
•
Cannot print the image at the size selected.
Disconnect the USB cable and reconnect it whenever you change the paper size after the
•
printer has been connected to the camera.
84
(Setup) menu (page 53).
(Do not disconnect USB cable) mark