GeekChef VMP-12A User Manual page 10

HOW TO USE
OPERATING INSTRUCTIONS
USING THE OVEN
The burner is rated at 14, 500BTU/Hr.
To begin:
1.Make sure the oven has been leak tested and properly placed.
2.Remove any remaining packing material.
3.Light the burner using the LIGHTING INSTRUCTIONS below.
LIGHTING AND ADJUST THE FIRE INSTRUCTION
1.Before use please make sure the control knob is in"OFF"position.Then push the control knob
and slowly turn the knob anticlockwise to"HI"position for 5 seconds until you hear a click and the
burner ignites(A) .
2.You can adjust the fire from HI to LOW by slowly turn the control knob cloclwish(B)
3.Please turn the control knob to"HI"position, then push the knob and colock wise to"OFF"po
tition to turn off your pizza oven.(C)
TO LIGHT WITH A MATCH
1.If burner will not light after several attempts using the control knob, the burner maybe lit with
a match.
2.If you have already attempted to light the burner using the control knob, wait few minutes for
any gas to dissipate.
3 Insert a match into the matchstick holder, ignite the match and insert through the oven
opening to the burner.
4.Push and turn the control knob to HI slowly, the burner should ignite immediately.
5.If the burner does not light within seconds, turn the control knob OFF and wait for 5 minutes
and try again.
9