KYMCO AHG1 Maintenance Manuallines page 211

19. ELECTRICAL SYSTEM
6. Luggage Box Light Sensor
6.1. INSPECTION
Remove the luggage box.
Disconnect the luggage box light sensor
connector and check the luggage box light
sensor for continuity between the sensor
terminals.
There should be no continuity with the
luggage box light sensor being covered up,
and there should be continuity with the
luggage box light sensor being not covered
up.
To inspect the lamp and sensor of luggage
box:
Sensor:
* Voltage supply range: 8~16V.
* It will light off 2 minutes later while
opening the rider seat.
* It will light off 3 seconds later while
masking the sensor below 4cm height.
Lamp:
* Disconnect the light coupler.
* Connect 8~16V power supply to the
terminal leads of lamp, then check whether
the illumination works or not.
19-11