Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Lippert SKYLINE
Summary of Contents for Lippert SKYLINE
- Page 1 Quick Start Guide SKYLINE Lippert eBike CCD-0005474...
- Page 2 Operation ................... 10 App Information ..............11 Introduction For up-to-date instructions on the assembly of the Lippert Skyline eBike, in-depth instructions on operating the bike and navigating the Lippert eBike app, and complete safety information, please use the link below or the QR code to navigate to the Owner's Manual.
- Page 3 Resources Required • 6mm Hex Key • 10mm Wrenches (2) • 4mm Hex Key • 15mm Box End Preparation 1. Unpack bike from box (Fig. 1). NOTE: Image for reference only. Actual eBike may be different. Fig. 1 2. Remove battery keys around seat post (Fig.
- Page 4 Installation 1. Install handlebars. A. Insert handlebar neck into front stem (Fig. 3). B. Adjust to desired height and center with front fork (Fig 4). Fig. 3 Fig. 4 NOTE: Do not raise above max height marking on neck (Fig. 4A). C.
- Page 5 D. Loosen handlebars and pivot (rotate up) to desired riding position (Fig. 6). Tighten with 6mm hex. Loosen Fig. 6 2. Install seat. A. Flip quick lock open (Fig. 7A) to allow the seat post to be inserted into the frame. Fig.
- Page 6 B. Insert seat into the seat post (Fig. 8). C. Flip quick lock to secure seat (Fig. 8A). NOTE: As seat is positioned, do not adjust outside of the range of the alignment marks. Fig. 8 3. For the next steps, it will be necessary to carefully maneuver eBike so the handlebars and seat are on the ground supporting the bike.
- Page 7 4. Install mudguard. NOTE: Nuts and bolts are installed in the frame for the mudguard. A. Use two (2) 10mm wrenches Fig. 9 to loosen nut from bolt. Remove nut, leaving the bolt and front reflector in place (Fig. 9). B.
- Page 8 5. Install front wheel. A. Place front wheel into fork, paying close attention to the position of the security washers into the designated retaining holes (Figures 12 and 13). B. Verify front wheel security washers are in proper position (Fig. 12A). Fig.
- Page 9 6. Install pedals. A. Insert pedals into crank arm (Fig. 14). Fig. 14 NOTE: Left (L) pedal is REVERSE THREADED. NOTE: Pedals are labeled right and left and must be put on the appropriate side (Fig. 15). Fig. 15 CCD-0005474 Rev: 06.15.22 Page 9...
- Page 10 7. Install front brake. A. Squeeze the right and left brake arms together (Fig. 16). Brake pads should be contacting the rim. Fig. 16 B. Insert the brake cable into quick-release lever (Fig. 17A). C. Test brake function. Fig. 17 CCD-0005474 Rev: 06.15.22 Page 10...
- Page 11 Operation 1. Charge the battery. 2. Insert the battery then turn the key to lock (Fig. 18). Fig. 18 3. Push ON/OFF switch to I position (Fig. 19A). Fig. 19 Fig. 20 4. Hold until on (Fig. 20) and select assistance level. 5.
- Page 12 Any unauthorized use shall void any applicable warranty. The information contained in this manual is subject to change without notice and at the sole discretion of LCI. Revised editions are available for free download from lippert.com. Please recycle all obsolete materials.
Need help?
Do you have a question about the SKYLINE and is the answer not in the manual?
Questions and answers