1. Manuals
  2. Brands
  3. Lippert Manuals
  4. Bicycle
  5. GLADIATOR Lippert
  6. Quick start manual

Lippert GLADIATOR Quick Start Manual

Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

Quick Start Guide
Lippert eBike
CCD-0005472

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GLADIATOR Lippert and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Lippert GLADIATOR Lippert

Summary of Contents for Lippert GLADIATOR Lippert

  • Page 1 Quick Start Guide Lippert eBike CCD-0005472...
  • Page 2 Operation ....................7 App Information ................... 8 Introduction For up-to-date instructions on the assembly of the Lippert Gladiator eBike, in-depth instructions on operating the bike and navigating the Lippert eBike app, and complete safety information, please use the link below or the QR code to navigate to the Owner's Manual.
  • Page 3 Installation 1. Unpack bike from box (Fig. 1). Fig. 1 2. Install the handlebar. A. Remove the four handlebar clamp bolts using a 4mm hex key (Fig. 2). B. Mount the handlebar on the stem. C. Tighten the four bolts gradually. One turn per bolt in an X pattern (Fig.
  • Page 4 3. Insert the front wheel. A. Locate front axle within the box (Fig. 4). B. Remove tensioning nut and one spring and place into front wheel hub (Fig. 5). Fig. 4 Fig. 5 Fig. 7 Fig. 6 NOTE: Narrow end of spring faces the wheel hub. Rev: 02.07.22 Page 4 CCD-0005472...
  • Page 5 C. Place spring (narrow side towards hub) and tensioning nut back onto the axle and leave loose (Fig. 6). D. Guide wheel into the fork, paying close attention to the brake-disc alignment into the brake caliper. Once seated, finger tighten the plastic nut with the tensioning arm open, then close the tensioning arm.
  • Page 6 B. Pull the rear brake lever to center the caliper on the disc for even pad contact on the rotor (Fig. 9). Fig. 8 Fig. 9 C. Keep hold of the rear brake lever, and tighten the allen bolts on the rear caliper (Fig. 10). D.
  • Page 7 Operation 1. Charge the battery. 2. Insert the battery then turn the key to lock (Fig. 12). Fig. 12 3. Push ON/OFF switch to I position (Fig. 13). Fig. 13 Fig. 14 4. Hold until on (Fig. 14) and select assistance level. 5.
  • Page 8 Any unauthorized use shall void any applicable warranty.  The information contained in this manual is subject to change without notice and at the sole discretion of LCI.  Revised editions are available for free download from lippert.com. Please recycle all obsolete materials.

Table of Contents