Teledyne 6712 Assembly, Installation And Operation Manual

6712 LTE Cellular Modem
Installation and Operation
Overview
This modem can transmit SMS text message alarms
to cell phones and/or email addresses, and receive SMS
text message commands, via the Internet.
Sampler firmware version 3.04 or newer is required for
the 6712 LTE modem. This firmware will only work with
C0 hardware.
To verify the hardware of your sampler:
1. Go to V R .
IEW EPORT
2. Select S ID .
YSTEM S
3. The hardware version will appear in the display.
Equipment part numbers:
• 6712LTE Cellular Modem Kit
(modem module with magnetic mount antenna)
Part #60-9004-499 - Verizon
Part #60-9004-517 - Other
• Antenna Only Part #60-4804-035
Note
When the 6712 LTE modem is used, the baud rate is
locked at 9600bps. Ensure that this setting is also
selected in Flowlink or Hyperterminal.
Programming the APN
The APN (Access Point Name – for Data) is stored in
the 6712 Sampler head.
1. Plug the com cable directly to the 6712.
2. Connect with a terminal program and type ????
3-4 times to log in. The Sampler will beep.
3. When you see the ">" type "APN" then E
The following screen will appear:
> APN
1. Name: empty
2. User: empty
3. Password: empty
Press 1,2,3 to change or 0 if ok
4. Choose "1" to input the APN.
> APN
1. Name: empty
2. User: empty
3. Password: empty
Press 1,2,3 to change or 0 if ok
Enter Name:
Information included herein is controlled by the Export Administration Regulations (EAR) and requires an export license, license exception or other
approval from the appropriate U.S. Government agency before being exported from the United States or provided to any foreign person. Diversion
contrary to U.S. law is prohibited.
5. Type in the name and press enter. The screen
will update with the APN below the entry screen:
> APN
1. Name: empty
2. User: empty
3. Password: empty
Press 1, 2, 3 to change or 0 if ok
Enter Name:i2gold
1. Name: i2gold
2. User: empty
3. Password: empty
Press 1,2,3 to change or 0 if ok
6. Pressing "0" to save the setting gets you the ">"
again. You can now disconnect via Terminal.
> APN
1. Name: empty
2. User: empty
3. Password: empty
Press 1, 2, 3 to change or 0 if ok
Enter Name:i2gold
1. Name: i2gold
2. User: empty
3. Password: empty
Press 1,2,3 to change or 0 if ok
>
7. Close the Terminal.
.
NTER
8. Now you can connect the modem to the sampler
and program the sampler accordingly.
6712 LTE Modem Activation
and Setup
The item in bold is the current selection; use the
arrow keys to scroll and press
Instruction Sheet #69-9003-676
Rev. F, May 2021
to accept:
RUN "EXTENDED 1"
PROGRAM
VEIW REPORT
OTHER FUNCTIONS
MAINTENANCE
MANUAL FUNCTIONS
SOFTWARE OPTIONS
HARDWARE