Advertisement
3. SPECIFICATION
Model No: ...................................................PPF20S/PPF30S
Capacity: ..................................................... 20tonne/30tonne
Maximum Height - Ram to Table: ............................... 875mm
Minimum Height - Ram to Table: .................................. 25mm
Overall Height: ......................................................... 1800mm
Ram Diameter: ........................................... Ø83mm/Ø102mm
Ram Stroke: ............................................................... 145mm
Screw Extension: ......................................................... 75mm
Table Aperture: ........................................................... 150mm
Total Ram Travel: ....................................................... 220mm
Type: ..............................................................................Floor
Working Table Depth: ................................................. 166mm
Working Table Width: ................................................. 710mm
4. ASSEMBLY
WARNING! these presses are heavy, the use of a lifting appliance is recommended.
‰
4.1.
FIT FEET fig.1
4.1.1.
Attach the permanent press feet.
4.1.2.
It is recommended that the press is secured to the floor using the fixing holes in the feet.
fig.2
4.2.
FIT PUMP HANDLE
4.2.1.
Fig.3: Assemble part 41 with parts 43 & 45.
4.2.2.
Fig.4: Assemble part 44 with parts 42 & 45.
4.2.3.
Fig.5: insert handle 25.
5. OPERATION
5.1. BLEED HYDRAULIC CIRCUIT fig.6
5.1.1.
Open pump compartment fig.6.1.
5.1.2.
Lift central plunger of oil filler plug part fig.6.2.
5.1.3.
Open release valve fig.6.3 by turning 180° counter clockwise.
5.1.4.
Pump handle fig.6.4 ten times.
5.1.5.
Close release valve 3 by turning handle clockwise.
5.1.6.
Press is ready to use.
5.2.
OPERATION
5.2.1.
Ensure press is fully assembled and bolted to a firm, regular horizontal
surface.
5.2.2.
Only to be used by fully trained operatives who have read and fully understood
the whole of this manual.
5.2.3.
Ensure working table is at the correct height and locked into position with its pins.
5.2.4.
Leave enough space around the press whilst it is being used.
5.2.5.
V blocks must be used in pairs not singly.
5.2.6.
Close release valve by turning clockwise. Pump the handle until the piston approaches
the workpiece.
5.2.7.
Align the workpiece and the piston so that the workpiece is properly centred.
5.2.8.
Pump the handle to apply pressure to the workpiece.
5.2.9.
When work is finished, stop pumping and open the release valve to remove the workpiece.
5.2.10.
When the press is not in use, ensure that the ram is retracted fully to help avoid corrosion
© Jack Sealey Limited
Original Language Version
fig.4
fig.3
fig.6
PPF20S , PPF30S Issue 1 18/02/22
fig.1
fig.5
Advertisement
