Advertisement
Weekly:
1.
Perform the daily cleaning steps 1 and 2.
2.
Remove the cover from the hair pocket assembly. (Diagram K) Place
the body of the shaver aside to ensure that it will not get wet.
3.
Slide the blue inner cutter carrier down to release it from the
assembly. (Diagram L)
4.
Remove the inner cutter carrier away from the cutters.
5.
Remove the cutters. (Diagram M)
6.
Thoroughly rinse away any debris from inner and outer cutters.
(Diagram N)
7.
Replace the inner cutters. Match the hub colors of the inner and outer
cutters (Diagram O)
8.
Place the inner cutter carrier back into position and lock into place.
(Diagram P)
9.
Lubricate each cutter with household oil.
10. Align the spring hinge into the slot at the back of the hair pocket and
press into place. Snap the head assembly closed. (Diagram J)
Trimmer: Lubricate teeth with oil every six months.
It is very important to replace your head and cutters when necessary to
ensure a close, comfortable shave without irritation. We recommend they
be replaced every 12 months. Here are some signs of head and cutter wear,
indicating that replacement is needed:
•
Irritation: As the heads get excessively worn you may experience
some skin irritation. This would be especially noticeable when you
apply moisturizing lotion.
•
Pulling: When the cutters wear you may feel a sense of pulling and a
loss of closeness when you shave. This is an indication that it is time
to replace your heads and cutters.
PRODUCT DISPOSAL
When your rechargeable shaver reaches the end of its useful life, the
batteries must be removed from the shaver and be recycled or disposed of
properly in accordance with your state and local requirements. If this is not
required by law, you may elect to dispose of the shaver with the batteries.
To Remove the Rechargeable Battery:
1.
Unplug the shaver.
2.
Run shaver until motor stops.
8
Advertisement
