Cleaning And Care; Product Disposal - Remington PR1340 Use And Care Manual

Cleaning and Care
.-
~
For washable models ONLY. The head
t,,
assembly part may be cleaned under wann water.
NOTE: When cleaning your shaver, make sure the shaver is turned off
and disconnected from the power cord.
CAUTION!
• To clean the external surfaces of the shaver, use a damp cloth. Do not use strong
detergents or other chemicals.
• To dry, wipe the surface of the shaver with a dry towel. Do not use a hair dryer
or heater to dry the shaver.
Daily:
D. I)
1. Press the release button on front of shaver and open head assembly. ( iagram
2. Tap out excess hair shavings. (Diagram J) .
3. Rinse the head of the shaver in running water. NEVER submerge the shaver m
water!
4.
Leave head open for drying.
5. Snap head closed before using the shaver again. (Diagram K)
II
weekly:
1. Perform the daily cleaning steps 1 and 2.
2. Remove the c~ver from the hair pocket assembly. (Diagram L) Place the body of
the shaver aside to ensure that 1t will not get wet.
3. Slide the blue inner cutter carrier down to release it from the assembly.
(Diagram
M)
4. Remove the inner cutter carrier away from the cutters.
5. Remove the cutters. (Diagram N)
6. Thoroughly rinse away any debris from inner and outer cutters. (Diagram O)
1.
Replace the inner cutters. Match the hub colors of the inner and outer cutters
(Diagram P)
s.
Place the inner cutter carrier back into position and lock into place. (Diagram Q)
9. Lubricate each cutter with household oil.
1
o.
Align the spring hinge into the slot at the back of the hair pocket and press into
place. Snap the head assembly closed. (Diagram
K)
Trimmer: Lubricate teeth with oil every six months
Product Disposal
When your rechargeable shaver reaches the end of its useful lite, the Lithium bat-
teries must be removed from the shaver and be recycled o_ r q1sposed of_ properly
in accordance with your state and local requir~ments. If th1_s 1s not required by
law, you may elect to dispose of the shaver with the batteries.
To Remove the Rechargeable Battery:
1. Unplug the shaver.
2. Run shaver until motor stops. .
3. Remove head from shaver (Press release button and pull head straight away
from shaver body)
4. Using a small screwdriver pry front cover from shaver body.
5. Remove four screws located on front of shaver. .
6. Remove rear cover from inner housing to exp~ battenes.
7 • Pry batteries free from circuit board and cut wires.
a.
Dispose of batteries. . .
·
f th f 11
·ng types of rechargeable batteries: mckel metal
~%~ii:v1~ft-X~t5n~1~1°cad~i~~(~i-td) or Lithium Ion (Li-Ion) (see included bat-
tery for i nd ica ion of
type).
ST BE RECYCLED OR DISPOSED
CAUTION: ALLDARNEg~i1,r:}:Lf
t~~~
1
f f
A~r AND LOCAL REGULATIONS. DO
OF IN ACCOR LATE AS THE BATTERY MAY BURST OR RELEASE
NOT PUT IN ~~lgRD~iTJT SHbRT-CIRCUIT, AS THIS MAY CAUSE BURNS.
TOXIC MATE . . d artici ant in the EPA-approved Rechargeable
Spectrum Bran
1
. ds,
t~,:i~e~~~~~M
~hichpcollects and recycles these batteries
Battery Recyc
mg
a !'fl h ' taken out of services in the United States or
~1~~~:~h~f
~i~t~~~6g~in~\;tvides a convenient alternative to placing used
II