Table of Contents
Advertisement
aus Rinse aid system
Tip: You can change this setting and
other Basic settings → Page 36 at
any time again.
11 Rinse aid system
11.1 Rinse aid
For optimum drying results, use rinse
aid.
Only use rinse aid for domestic dish-
washers.
Adding rinse aid
If the rinse aid refill indicator lights
up, top up with rinse aid. Only use
rinse aid for domestic dishwashers.
Press the catch on the lid of the
1.
dispenser for rinse aid
.
Add rinse aid up to the max mark.
2.
28
and lift
2
1
max
If rinse aid spills out, remove it
3.
from the tub.
Spilled rinse aid can cause ex-
cessive frothing during the wash
cycle.
Close the lid of the dispenser for
4.
rinse aid.
a The lid clicks into position.
11.2 Setting the amount of
rinse aid
If there are streaks or water marks on
tableware, change the amount of
rinse aid.
Press
.
1.
To open the basic settings, press
2.
for 3 seconds.
a The display shows
Press
3.
the display shows the value set at
the factory r:05.
Press
or
4.
right amount of rinse aid has been
set.
– A low setting adds less rinse aid
during the wash cycle and re-
duces streaking on tableware.
– A higher setting adds more
rinse aid during the wash cycle,
reduces water marks and im-
proves the drying result.
To save the settings, press
5.
for 3 seconds.
.
repeatedly until
repeatedly until the
Advertisement
Table of Contents
