Table of Contents
Advertisement
Open door button
A
B
ON-OFF and washing
programme selection knob
C
Time remaining shown on
display LED
D
Spin speed shown on
display LED
E
Heating phase LED
Display
F
Select spin speed button or
G
stop with tub full
Press the button to open the door. Chapter 5 – Washing
instructions – explains how the door works and how to use it.
This knob lets you:
•
switch the machine on and off by moving it in either
direction from the OFF position (knob indicator
vertical)
•
select washing temperatures within the various
fabric sectors by turning it in both directions
The knob does not move while the programme is running.
The programme is electronically controlled by the machine.
This LED indicates that the display is showing the total
duration of the selected programme before the programme
starts, and the time remaining while the programme is
running.
This LED indicates that the display is showing the maximum
spin speed for the selected programme. It stays on while spin
speed is being selected with the relative button.
During the heating cycle, this LED indicates that the
programme is in the washing water heating phase.
The display shows the following information:
1.
time remaining for the selected programme, given
hours/minutes.The stated value is an estimate based on the
achine's normal operating parameters (size of load, incoming
ater temperature, etc.). The program time may therefore be a
w minutes longer or shorter than stated here.
2.
delayed start (for models featuring this option).
iven in hours/minutes. When the time remaining before the
rogramme starts is less than 60 minutes, this information is
ven in minutes/seconds.
3.
spin speed
4.
cycle pause - flashing STOP
5.
end of cycle - END
6.
error codes
To find out which of the first 3 pieces of information are
hown on the display, check which of the LED's, C, D, or N (the
tter for models featuring the delayed start option) is lit.
Press the button repeatedly to select the required spin
speed. The following spin speeds are available:
•
0000: spin disabled and stop with tub full. The
machine does not perform the final spin and ends the
washing programme with water in the tub. To drain
the water, see the explanations shown in paragraph
5.14
•
from 600 rpm to the maximum speed indicated for
the model: for cotton and coloured programmes,
speed increases by 100 rpm starting from 600 rpm
up to the maximum speed indicated for the model
•
from 600 to 900 rpm: for synthetics, delicates and
woollens programmes, speed increases by 100 rpm
GB
9
Advertisement
Table of Contents
