All manuals and user guides at all-guides.com
Temperature & rH Data Logger
1.
Your new logger comes ready to go.
Simply press and hold the
Preset high
and low alarm
levels
Status LEDs
2.
Now place your logger in the location you want to monitor.
Once logging, pressing the
the status. It will also add a marker to the data to show that you have checked it.
No alarms will be triggered in the first 30 minutes to allow the logger to settle at
the monitored conditions.
Green single flash
The data logger is currently logging
No alarm has been triggered
Red single flash
The data logger is currently logging
An alarm has been triggered!
Green double flash
The data logger's memory is full
No alarm was triggered
Red double flash
The data logger's memory is full
An alarm was triggered!
No LEDs flash
The data logger is stopped or the battery is flat
www.tiptemp.com
button until the green LED lights up to start logging.
button will light up an LED to give a quick indication of
QUICK START GUIDE
Push to start
Sensor
No action required
Check alarm condition in PC software
Plug your logger in to a PC and download
your readings
Plug your logger in to a PC, download your
readings and check alarm condition
Check the logger's status using the PC software