Panasonic HDC-SD90P Service Manual page 40

Service Manual
Diagrams and Replacement
Parts List
High Definition Video Camera
Model No.
HDC-SD90P HDC-SD90EG
HDC-SD90PC HDC-SD90EP
HDC-SD90EB HDC-SD90GC
HDC-SD90EC HDC-SD90GN
HDC-SD90EE HDC-SD90GK
HDC-SD90EF HDC-SD99EG
Vol. 1
Colour
(K)...........Black Type
(S)...........Silver Type (only HDC-SD99EG)
(H)...........Glay Type (only HDC-SD90EB)
Table of contents
S1. About Indication of The Schematic Diagram ............................ S-1
S1.1. Important Safety Notice......................................................... S-1
S2. Voltage Chart ........................................................................... S-2
S2.1. SD P.C.B. .............................................................................. S-2
S3. Block Diagram .......................................................................... S-3
S3.1. Overall Block Diagram .......................................................... S-3
S4. Schematic Diagram .................................................................. S-4
S4.1. Interconnection Diagram ....................................................... S-4
S4.2. SD Schematic Diagram ......................................................... S-5
S4.3. Monitor Schematic Diagram .................................................. S-6
S5. Print Circuit Board .................................................................... S-7
S5.1. SD P.C.B. .............................................................................. S-7
S5.1.1. SD P.C.B. (Component Side) ............................................. S-7
S5.1.2. SD P.C.B. (Foil Side) .......................................................... S-8
S5.2. Monitor P.C.B. ....................................................................... S-9
S5.2.1. Monitor P.C.B. (Component Side) ...................................... S-9
S5.2.2. Monitor P.C.B. (Foil Side) ................................................. S-10
VM1102017CE
S1. About Indication of The Schematic Diagram
S1.1. Important Safety Notice
COMPONENTS IDENTIFIED WITH THE MARK
FOR SAFETY. WHEN REPLACING ANY OF THESE COMPONENTS USE ONLY THE SAME TYPE.
1.Although reference number of the parts is indicated on the P.C.B. drawing and/or
2.It is only the "Test Round" and no terminal (Pin) is available on the P.C.B.
3.The voltage being indicated on the schematic diagram is measured in
HDC-TM90P
4.Although the voltage and waveform available on here is measured with standard frame,
HDC-TM90PC
HDC-TM90PU
5.The voltage being indicated here may be include observational-error (deviation) due to
HDC-TM90GK
HDC-TM99EG
6.Use the parts number indicated on the Replacement Parts List .
7.Indication on Schematic diagrams:
S6. Replacement Parts List .......................................................... S-11
S7. Exploded View ....................................................................... S-17
S7.1. Frame and Casing Section (1) ............................................ S-17
S7.2. Frame and Casing Section (2) ............................................ S-18
S7.3. LCD Section ........................................................................ S-19
S7.4. Packing Parts and Accessories Section .............................. S-20
schematic diagrams, it is NOT mounted on the P.C.B. when it is displayed with "$" mark.
when the TP (Test Point) indicated as "
"Standard-Playback" mode when there is no specify mode is mentioned.
it may be differ from actual measurement due to modification of circuit and so on.
internal-resistance and/or reactance of equipment. Therefore, handle the value
indicated on here as reference.
Circuit name being connected.
OFTR FEP
Name of Signal
S-1
HAVE THE SPECIAL CHARACTERISTICS
" mark.
This signal is connected
to the FEP schematic diagram.