Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Landis P-220
Summary of Contents for Landis P-220
- Page 1 P-220 ORTHO MOBILE MINI SANDER Operator Manual Manufactured...
- Page 2 MERGENCY WITCH ON/OFF WITCH ANDING EVICE SANDING ON BAYONET DEVICE ON BAYONET VENT VENTS & BEARING ACCESS REMOVABLE TRAY FRONT PANEL FOR DUST DRAWER ACCESS...
- Page 3 P-220 ORTHO MOBILE MINI FINISHING SANDER INTRODUCTION The P-220 Ortho Mobile Mini Finishing Sander is a compact, durable machine designed for fast, complete finishing work. It will deliver efficient, dependable service when used correctly and with care. As with any piece of specialized equipment, for best performance the manufacturer’s instructions must be followed.
-
Page 4: Installation
INSTALLATION The Landis Sander should be located on a flat, firm surface, in an area free of obstructions that could interfere with the safe operation of the equipment. The Sander should be positioned, leveled and the wheels on a locked position. - Page 5 Eye protection is required for protection from flying debris and dust, which could cause eye injury. Before shipment, your Landis Sander was checked at the factory for proper adjustment and operation. However, due to the possibility of jarring or damage during handling and shipping, it is necessary to check that the machine is in proper working order before use.
-
Page 6: Maintenance
WARNING: Eye protection should always be worn by the operator and others in the work area when using the accessories supplied with the Landis Sander. Eye protection is required for protection from flying debris and dust, which could cause eye injury. - Page 7 DAILY AND WEEKLY MAINTENANCE Clean your Landis Sander daily. Shake dust bag daily. Empty it weekly. After cleaning the machine, turn dust extraction motor off. While the motor is coasting to a stop, shake bag vigorously. The cleaner you keep the dust bag, the less likely you are to burn a hole in it.
-
Page 8: Monthly Maintenance
Lubrication will only attract dust and would be more harmful than helpful. V-BELT ADJUSTMENT AND REMOVAL The V-Belt on the Landis Sander should be checked monthly for proper tension and general condition. Loose V-Belt will decrease the power available to the various tools and lower the efficiency of your Sander. -
Page 9: Motor Replacement
TO CHECK V-BELT TENSION: Disconnect the electrical power supply. Check the tension of the V-belt running to the motor; it should depress approximately ½” when pressed in the middle with moderate force. Rotate the V-belt by hand, visually inspecting the belt for damage. If tensions or conditions are bad, adjust tension or replace V-belt. - Page 10 Disconnect the electrical wires and the connector on the motor box. Remove the eight (8) nuts and washers holding the fan housing to the machine. Remove entire assembly of fan housing and motor plate from the machine. Remove the top cover by loosen the ten (10) screws on top of the motor shaft.
- Page 11 SANDING MOTORS To remove the motor, these procedures should be followed: Disconnect the electrical power supply. From the rear of the machine, remove the four (4) screws, nuts, and washers holding the motor. Remove V-belt. Disconnect the electrical wiring by removing the electrical plate on the end of the motor.
Need help?
Do you have a question about the P-220 and is the answer not in the manual?
Questions and answers