Table of Contents
Advertisement
X 4.2 Stand removal & VESA mount installation
This monitor provided with a validated stand. The monitor has been designed to be used in
landscape position with a maximum tilt of -5° to 30° backward. If a different stand is needed
in the final application, the monitor VESA interface (VESA 100 mm standard) could be used.
To remove the stand and install the VESA mount
1. Place the monitor face down on a flat, solid and stable surface.
2. Remove the hinge cover
3. Unscrew the 4x M4 (length: 10mm) screws fixing the stand and rear cover
4. Remove the stand and install the VESA mount.
Caution: Use a protective cloth or cushion to prevent the monitor and LCD from any
damage or scratches.
Attention: Utilisez un chiffon ou un coussin de protection pour éviter d'endommager
ou rayer le moniteur et l'écran LCD.
Tip: Store the fixation screws at a known place for possible future use.
Image 4-2-1 Remove the hinge cover
User's Manual | MDPi Series
Image 4-2-2 Remove the 4x M4 screws
Image 4-2-3 Remove the stand from the monitor
Chapter 4
Monitor Installation
16
Advertisement
Table of Contents
