Liberty 011000301 Installation Manual

Product Installation Disclaimer
● Failure to install this product according to these
instructions will invalidate the warranty. This includes, but
is not limited to using alternative installation methods,
hardware, or materials.
● DO NOT USE Loctite, SuperGlue, or similar products on
the hardware or the product.
● Verify the fit of the product to vehicle prior to installation
● if painting is desired it must be done prior to installing
product on vehicle. Clean outer surface with a good grade
degreaser.
● DO NOT USE LACQUER THINNER OR ENAMEL
REDUCER AS A DEGREASER. Wipe outer surface
thoroughly with a tack rag prior to paint. Application of
plastic adhesion promoter for ABS plastic as per your paint
system manufacturer's recommendations is required. Paint
flares using a high quality enamel, or polyurethane
automotive paint. Do not paint edge trim.
● Using larger tires may increase area required to turn the
vehicle. Some wheel and tire combinations may require
lowering bump stops and or installing steering stops to
prevent tire from contacting flare while turning.
● Exhaust system modifications require minimum 4"
clearance between flares and exhaust pipes and exhaust
gases should not vent directly onto product.
● All exposed fasteners and bare metal should be treated
with rust resistant paint BEFORE installing flares. Spray
inner fender wells with undercoating AFTER flare have
been attached.
● This product may interfere with existing decals on vehicle.
If you wish, remove decals prior to installation of flares.
● Care & Cleaning: Do not use any harsh abrasive
detergents.
PLEASE NOTE
Dirt and debris can become lodged between the product
and the body, causing scratching and paint wear from
vibration. Liberty Products is not responsible for any
damage, and the installation of this product is done with
the buyer's understanding that this scratching and paint
wear may occur.
Liberty Products | Installation Guide for Part # 011000301
Installation Guide
Part #​ 011000301
Fitment Info: libertyproducts.com
Hardware Kit Components
CLP-003
CLP-004
SCR-001
WSH-001
Installation Tools Required
1. T-15 torx bit
2. #2 Phillips screwdriver
3. 10mm socket
4. ½" wrench
5. Tape measure
NUT-001
PAD-001
SCR-002
SCR-003
1