Universal Remote Control; Digi Link System Remote Controls - Sherwood Newcastle R-956 Operation Instructions Manual

Universal Remote Control

Note: For additional Universal Remote Control programming instructions and manufacturer's codes, please refer to the
operating manual enclosed with this Universal Remote Control.
This remote control has 3 operating modes as follows;
• OSD (On-Screen Display) Mode: Allows you to see information about basic operation of this unit on your TV or monitor
• Sherwood Mode: Allows you to operate this unit and other Sherwood components like cassettte decks, CD players, etc. via
the remote control. (To operate other Sherwood components, please make the Digi Link connections
between the components.)
• Non-Sherwood Mode: Allows you to operate other brands of audio and video components that are remote compatible.
Notes:
• The setup code for each component must be entered before the remote will operate the component.
• For setup codes (manufacturer's codes), please refer to the "MANUFACTURER'S CODES" in the operator's manual that
came with the remote control.
• The buttons may have different functions depending upon the chosen component and the operating mode.
• Please be sure to set the remote control to the correct component mode before trying to operate any component.
DIGI LINK SYSTEM REMOTE
• This section explains the basic functions for the Sherwood and the OSD modes. For the non-Sherwood mode, please refer
to the operating manual that came with the remote control.
• All Sherwood components bearing the DIGI LINK (II or III) logo can be used with this remote control.
• To control associated Sherwood Digi LInk components, you must first make the DIGI LINK connections between the
components.
• With the Sherwood Digi Link III system, pressing a transport control button such as PLAY, on a Sherwood CD player or
tape deck will automatically engage that input on the receiver and then PLAY will start.
• The numbered buttons on the remote control have different functions in different modes. For details, please refer to the
"FUNCTION TABLE for the NUMBERED BUTTONS" on the following page.
• Each time a button on the remote control is pressed, the buttons will illuminate for approximately 5 seconds.
LED LAMP
SETUP BUTTON
COMPONENT BUTTONS
• To operate the desired component
with this remotecontrol, first select the
corresponding COMPONENT button.
VOLUME UP/DOWN
( / ) BUTTONS
ENTER BUTTON
and to operate this unit by moving an arow(cursor) that appears on the TV screen.
PWR
AUD CD DVD AUX
SAT TV VCR CBL
1 2 3
4 5 6
7 8 9
0
MUTE CH SEL
P.SCAN
SLEEP
VOL CH LEVEL
T.TONE
D.TIME D.ADJ
ENTER
OSD
AUTO STEREO
DSP MODE 6.1CH IN
PHONO CD TUNER TAPE MON
T2 MON VID SEL VID 2 VID 3
VID 4 AUX ROOM 2 SYS DISP
HOME THEATER MASTER
RNC-30
1 0
POWER BUTTON
NUMERIC(1~0) BUTTONS
• For selecting preset stations in tuner mode.
• For selecting a track or a disc in CD mode, etc.
• When selecting a disc, select disc No. (1~5)
within 2 sec. after pressing DISC(marked "P.SCAN") button.
CHANNEL LEVEL UP/DOWN
( / ) BUTTONS
CURSOR CONTROL( , , , ) BUTTONS
• For moving an arrow with the CURSOR CONTROL
buttons in the OSD mode.