Package Contents Raspberry pi mounting M2.5*5 for Raspberry M3*4 screw for M3*5 screw for SSD×16 bracket×4 pi×16 frameworks×32 M5*10 screw for fans×8 Fan adapter×1 Framework×4 Foot pad×4 8cm Cooling fan ×2 Bottom panel (top Side panel×2 Front panel×1 Back panel×1 panel)...
Page 3
Installation 2. Fix cooling fans with M5 * 10 screws. 3. Install two frameworks to the back panels. Please note that all the screws for the enclosure are M3 * 4 countersunk screws. 4. Mount the side panels to the frameworks.
Page 4
Installation 5. Install two frameworks on the other side of the side panel. 6. Mount the front panel. 7. Use the top panel to cover the top of the enclosure.
Page 5
Installation 8. Snap the bottom panel into the enclosure. 10. Mount the Raspberry Pi with M2.5 *5 screws. 9. Insert the 2.5-inch SSD into the mounting bracket, align the direction of the mounting hole, and fix it with M3*5 screws. 11.
Page 6
Installation 12. Polarity diagram of fan adapter. 13. Connect the fan wire to the fan adapter board. Please pay attention to the red-and-black wires. Red represents the positive pole and black represents the negative pole. 14. Tilt and insert the installed bracket into the case and fix it with Captive Loose-O Screws.
Page 7
Installation 15. Insert the other Raspberry Pi mounting brackets into the enclosure. 16. Finally stick the footpads to the bottom panel. The installation is complete.
Page 8
CONTACT US If any problem, feel free to contact us. Website: www.uctronics.com Email: support@uctronics.com...