Summary of Contents for NASAB RW-91
- Page 1 External Rewinder RW-91 ART.Nr: 95-50-22. Edition 1:1 December 1998 - Art. No. 10-50-22...
- Page 2 RW-91 – Service Manual INTRODUCTION 1. Introduction 2. Connection 3. Adjustment 4. Printing & Rewinding 5. Hints 6. Specification 7. Spares 8. Options 9. Elschema...
- Page 3 RW-91 – Service Manual Note: 18V/AC adapter is normally ordered separately Connection: - Put the printer on a table with enough space in front of it. - Fit the rewinder in the front. - Connect the Adapter with the cable from the 18V/AC input plug on the rewinder control panel to the power mains socket.
-
Page 4: Specification
RW-91 – Service Manual Hints: - To get a perfect rewinded roll when printing batches of labels some points are suggested if possible. However the rewinder makes a good job without these proposals. - In printers Setup use no “negative startadjust”. This will avoid retracting the label before printing. -
Page 5: Spare Parts
RW-91 – Service Manual Spare Parts: Art. No.: Model: 59-10-11 Friction Clutch 59-10-13 Motor assy 59-10-31 Shaft, motor-bobbin 59-20-10 Tubular belt 59-20-12 Bobbin including support wing 59-20-15 Ball Bearing (bobbin) 59-20-16 Support wing 59-20-20 Electronik pc-board assy 59-20-21 Pulley (bobbin) - Page 6 RW-91 – Service Manual Elschema: Layout Wichrowa 49 Phone: +48(0)34 3654405 42 200 Czestochowa Fax: +48(0)34 3654489 Poland Email: info@nasab.com...