Page 3
RW-91 – Service Manual Note: 18V/AC adapter is normally ordered separately Connection: - Put the printer on a table with enough space in front of it. - Fit the rewinder in the front. - Connect the Adapter with the cable from the 18V/AC input plug on the rewinder control panel to the power mains socket.
RW-91 – Service Manual Hints: - To get a perfect rewinded roll when printing batches of labels some points are suggested if possible. However the rewinder makes a good job without these proposals. - In printers Setup use no “negative startadjust”. This will avoid retracting the label before printing.