Overheat Protection; Tip-Over Protection - HOMCOM 820-251V70 Assembly & Instruction Manual

Warning: The heater will remain hot for some time after it is turned off; handle with
care.

OVERHEAT PROTECTION

This heater is protected with an overheat protection that switches off the heating
automatically in case of overheat,e.g. due to the total or partial obstruction of the grids. In
this case, waiting to the appliance cool and removing the object which is obstructing the
grids. Then the thermal cut-out will automatically reset, heating as normally.
Should the problem persist, please contact the nearest customer service.

TIP-OVER PROTECTION

This heater is protected with a safety switch that turns off the appliance automatically when
the heater falls over, or is at an excessive angle from the horizontal. This helps prevent
accidents, and the heater will back to the standby mode when it is put back upright, press
the buttons on control panel or remote control to reset the heater
Remote control and Battery
The remote control requires 1 CR2025 3V lithium battery (included)
Important: Follow the instructions of use and the recycle rules given on the battery
packaging.
1- Open the battery compartment by sliding the cover down.
2- Insert the battery into the compartment,
observing the polarity in the diagram (see below drawing).
3- Close the battery compartment.
5
EN