AirTech UT150SC Installation And Wiring Instructions

UT150SC/B
Installation and Wiring Instructions

SAFETY AND GUIDANCE NOTES

All wiring to be in accordance with the current I.E.E.
Regulations, or the appropriate standards of your country and
MUST be installed by a suitably qualified person.
The Fan should be provided with a local isolator switch
capable of disconnecting all poles, having a contact
separation of at least 3mm.
Ensure that the mains supply (Voltage, Frequency, and
Phase) complies with the rating label.
The Fan should only be used in conjunction with the
appropriate Airtech products.
The fan should only be used in conjunction with fixed wiring.
When the Fan is used to remove air from a room containing a
fuel-burning appliance, ensure that the air replacement is
adequate for both the fan and the fuel-burning appliance.
The Fan should not be used where it is liable to be subject to
direct water spray for prolonged periods of time.
Where ducted Fans are used to handle moisture-laden air, a
condensation trap should be fitted. Horizontal ducts should be
arranged to slope slightly downwards away from the Fan.
This appliance is not intended for use by persons (including
children) with
capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of
the appliance by a person responsible for their safety.
Young children should be supervised to ensure that they do
not play with the appliance.
This product should not be disposed of with household waste. Please recycle where facilities exist. Check with
your local authority for recycling advice.
reduced physical,
IP65
sensory or mental