Table of Contents
Advertisement
NORMAL RECORDING
Action to Take when the Video Signal
Deteriorates
If there is no video signal during recording, fast forward,
rewind modes, when in stop mode or when a tape is not
loaded the menus are not displayed, "VIDEO LOSS" can
be displayed on-screen and a signal (0 V) can be output
at the ALARM OUT terminal. If in the (SET UP 5) menu
"WARN.OUT" is set to "V.LOSS" or "T OR V", a signal
(0V) will output at the WARNING OUT terminal.
If in the (SET UP 3) menu, in the BUZZER section
WARNING is set to "Y", the buzzer will be heard. To stop
the buzzer, press the STOP button.
1
Press the MENU button until the (SET UP 4) menu is
displayed.
@@@@@@@<SET@UP@4>
öALARM@MODE@@@@@@Y
öALARM@DURATION@@20S
öVIDEO@LOSS@@@@@@N
2
Press the ] button, until the "VIDEO LOSS" setting is
flashing.
3
Press the l (or j) button, to set the desired mode.
N . . . . . . . . . . The video loss warning is not
active.
Y . . . . . . . . . . The video loss warning is active.
4
Press the PAUSE/SEARCH button to save the
setting.
English
Tape Counter Notes:
There is no tape counter indication for the blank
portions of the tape.
The tape counter indicates real hours, minutes and
seconds.
There may be a slight discrepancy between the position
shown on the tape counter and the actual tape position.
When rewinding the tape past the "0:00:00" position, a
minus (–) sign will be displayed.
When the counter is displayed on the digital display
panel, press the COUNTER RESET button to reset it to
0:00:00.
13
Advertisement
Table of Contents
