Advertisement
Main parts
№ Name
1
On-/ Off switch
2
Base with pre-drilled holes
Assembly
The machine vibrates when in operation, and so it can move around while working. To prevent this, we
recommend screwing the machine firmly to the work table or a suitable base. The base of the polishing
machine has corresponding pre-drilled holes.
1.
Place the machine in the designated place on the table.
2. Mark the locations for the holes through the pre-drilled holes in the device base.
3. Drill the holes at the points marked.
4. Secure the machine to the table with two long screws, washers, lock washers and nuts (not
included).
Installation
Installation and removal of the polishing discs
Before installing or changing the polishing disc, make sure that the polishing machine is switched off
and unplugged.
1.
Remove the flange nut from the shaft with a 24-sized wrench (size may vary depending on the
version). Note that the left washer nut is left hand threaded.
2. Remove the polishing pad.
3. Check the new polishing pad for damage.
4. Install the polishing pad and tighten the nut. Make sure the nut is properly tightened. If the nut
is too tight or too loose, it can cause problems during operation.
5. When restarting the machine, do NOT stand in front of the machine, but to the side. Allow the
polishing pad to turn without load for at least 30 s. If the machine vibrates heavily or if any other
damage is noticed, pull out the power plug immediately. Fix the damage before putting the ma-
chine back into operation.
Caution: The polishing disc continues to rotate even after the plug has been pulled out.
•
Switching the machine on and off is safe when used properly. Follow all safety instructions, but
remember to use common sense in every situation and in all working conditions.
https://www.XPOtool.com
The Tool Experts
№ Name
3
Polishing pad
Item 62542
Page 5
05 2022-1
Advertisement
