Table of Contents
Advertisement
Before calling for repair service, check the following items for possible remedies to an encountered
symptom.
Symptoms
No power
No picture
Good picture but no sound
Good sound but poor color
Poor picture
Horizontal dotted line
Remote operation fails.
Snowy picture and noise
No stable or not
synchronized VGA picture
No output from one
of the speakers
Control buttons do not work.
Do not use in hot and cold rooms (locations)
+
• When the unit is used in rooms (locations) with low temperature, the picture may leave trails or appear slightly delayed. This is not
a malfunction, and the unit will recover when the temperature returns to normal.
• Do not leave the unit in a hot or cold location. Also, do not leave the unit in a location exposed to direct sunlight or near a heater, as
this may cause the cabinet to deform and the PDP panel to malfunction.
(Storage temperature: 0°C to +50°C Working temperature: 5°C to +40°C )
Note:
If your problem is not solved, turn your unit off and then on again.
Never attempt to repair a PDP TV yourself.
Troubleshooting
=
Check that the AC power cord is plugged into the mains socket.
=
Unplug the power cord, wait for 60 seconds. Then re-insert plug into the mains
socket and turn on the unit again.
=
Check video connections at the rear of the unit to see if it is properly connected to
the unit.
=
Adjust the contrast and brightness settings.
=
Select a correct input.
=
Is a non-compatible signal being input?
=
Increase the VOLUME.
=
Check that the unit is not muted.
=
Adjust the contrast, color and brightness settings.
=
Sometimes, poor picture quality occurs when an activated S-VHS camera or
camcorder is connected while another activated peripheral is connected. In this case,
switch off one of the peripherals.
=
Check whether the room is too bright.
=
This may be caused by electrical interference (e.g. hairdryer, nearby neon lights,
etc.).
=
Turn off the equipment.
=
This remote control is a universal remote control. If the remote control does not
work correctly when operating the monitor, try pressing the TV button.
=
Check whether the batteries are working. Replace if necessary.
=
Clean the remote control sensor lens on the unit.
=
Do not use the remote control under strong or fluorescent lighting.
=
The batteries should be inserted with polarity (+, -) aligned.
=
Check the A/V connections.
=
Check if you have selected the correct VGA mode in your PC.
=
Adjust Balance in the SOUND menu.
=
Unplug the power cord, wait for a few seconds. Then re-plug the power cord and turn
on the unit again.
28
Check item
Advertisement
Table of Contents
