Download Print this page

A-Tach Mounts ST-1 Instructions

The vehicle mount for lexus gx 2010-2021

Advertisement

Quick Links

A-Tach # 50388
Designed for: Lexus GX 2010 - 2021
For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFORE
attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the
mount will appear to be a little too big or small for the intended location. The vehicle mount must be
installed BEFORE a device holder is screwed onto the vehicle mount.
Once screwed together the products are considered used and non-refundable.
The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.
Once it is attached, it should remain attached until you would like to permanently remove it.
WARNING:
AVOID extreme heat conditions. It can damage the device and the mount.
(1) Clean the area where the mount will attach. The
top of the mount will attach into the seam and
under the top display frame illustrated with the
arrow in the photo.
(3) Remove the covering from the tape. Hook the
lower edge of the mount under the top edge of the
display frame. See photo.
See additional instructions on the back side.
ST-1
NOTICE: A-Tach Mounts will not be responsible for
any damage to the vehicle due to the installation
and/or use of the product. The product has been
tested to fit securely to the listed vehicles.
Instructions are provided for your convenience.
You are responsible for the use of the product and
to determine if you have the skill to attach the
product without causing damage to your vehicle or
the product.
Read all instructions and view the photos before
attaching this product.
(2) Insert the thin end of the seam tool into the
top seam to open the seam a little.
(4) Press forward on the top of the mount and, at
the same time ...
A-Tach
Mounts

Advertisement

loading

Summary of Contents for A-Tach Mounts ST-1

  • Page 1 A-Tach # 50388 A-Tach ST-1 Mounts NOTICE: A-Tach Mounts will not be responsible for any damage to the vehicle due to the installation and/or use of the product. The product has been tested to fit securely to the listed vehicles.
  • Page 2 A-Tach Mounts responsibility. A-Tach Mounts will not be responsible for any damage to the vehicle or product due to the installation and/or use of the product. A-Tach is not responsible for damages caused by extreme heat conditions.

This manual is also suitable for:

50388