RITE-HITE GUARDRITE STRAP Installation And Owner's Manual

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Download this manual

GUARDRITE

STRAP

BARRIER SYSTEM

INSTALLATION AND OWNER'S MANUAL

THIS MANUAL COVERS ALL UNITS SHIPPED APRIL 2006 TO DATE

PRINTED IN U.S.A.

PUBLICATION NO. GUARDRITE STRAP REV 3.1

RITE-HITE

PRINT SHOP

Table of Contents

Need help?

Do you have a question about the GUARDRITE STRAP and is the answer not in the manual?

Questions and answers

Summary of Contents for RITE-HITE GUARDRITE STRAP

Page 1 GUARDRITE ® STRAP BARRIER SYSTEM INSTALLATION AND OWNER’S MANUAL THIS MANUAL COVERS ALL UNITS SHIPPED APRIL 2006 TO DATE PRINTED IN U.S.A. PUBLICATION NO. GUARDRITE STRAP REV 3.1 RITE-HITE PRINT SHOP © OCTOBER 2013...
Page 2: Table Of Contents
STRAP SYSTEM BARRIER from RITE-HITE IMPORTANT Read and understand contents of this manual prior to installation or operation of this equipment. ® For best results, have this product serviced by your authorized RITE-HITE Representative. NOTICE TO USER ® Your local RITE-HITE Representative provides the Planned Maintenance Program (P.M.P.) which can be fitted to your...
Page 3: Safety Warnings
RITE-HITE ® Corporation does not recommend any particular lockout device, but recommends the utilization of a device that meets OSHA standards (refer to OSHA regulation 1910.147). RITE-HITE ® Corporation also recommends the review and implementation of an entire safety program for the Control of Hazardous Energy (Lockout/Tagout).
Page 4: Tools And Components
STRAP SYSTEM BARRIER TOOLS AND COMPONENTS TOOLS REQUIRED: Hammer Drill 3/4” Concrete Bit for Hammer Drill, Minimum 6” long Impact wrench with 15/16” socket 3/4” Rachet 3/4”Combination Wrench Chalk Line Tape Measure . GUARDRITE STRAP REV 3.1 - © JUNE 2013...
Page 5: Notices
GUARDRITE STRAP MODELS The Guardrite STRAP is available in two different models: The standard model is capable of stopping a 10,000 lb. fork truck moving at 4 mph. The light duty model is intended only to guide and restrict pedestrians. See the note below for expected deflection distances to aid in application.
Page 6: Installation Instructions
Offset Hole Pattern for Bracket Alignment Single Post with Tensioner Bracket Figure 3 Figure 5 Double Post with Tensioner Bracket Triple Post with Tensioner Bracket and and Storage System Storage System Figure 4 Figure 6 . GUARDRITE STRAP REV 3.1 - © JUNE 2013...
Page 7: Storage System
Check to make sure you have allowed for the necessary strap deflection if Storage System on Single Post with Tensioner Assembly your system is intended to stop heavy traffic. Figure 7 . GUARDRITE STRAP REV 3.1 - © JUNE 2013...
Page 8: Strap Attachment
These bolts will be tightened later after the strap lengths are matched. Repeat this process for the second strap. Double Strap Restraining Kit with Storage System Figure 9 . GUARDRITE STRAP REV 3.1 - © JUNE 2013...
Page 9: Shortening Of Straps
(17.5" from the top of the base bracket). Insert the self drilling screw through the second grommet in the strap handle and drive the self drilling screw into the strap and latch bar at this level. . GUARDRITE STRAP REV 3.1 - © JUNE 2013...
Page 10: Operation
Return to the storage system and turn the storage rod to wrap the straps around the storage rod. . GUARDRITE STRAP REV 3.1 - © JUNE 2013...
Page 11 Tension the strap until it is completely horizontal the straps should be replaced. and it does not have any slack or sag. Fully insert the lock pin through the tensioner and tensioner bracket. . GUARDRITE STRAP REV 3.1 - © JUNE 2013...
Page 20: Warranty
Periodic lubrication and ® ® adjustment is the sole responsibility of the owner. This warranty is RITE-HITE exclusive warranty. RITE-HITE EXPRESSLY DISCLAIMS ALL IMPLIED WARRANTIES INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS. Non- ®...

RITE-HITE GUARDRITE STRAP Installation And Owner's Manual

Quick Links

Need help?

Questions and answers

Related Manuals for RITE-HITE GUARDRITE STRAP

Summary of Contents for RITE-HITE GUARDRITE STRAP

Table of Contents