Dip-Switch Sw2 - golmar RD-PLUS/UNO SE Instruction Manual

CONFIGURATION
D
escription of the configuration jumper.
End of line resistor.
Set to On if the video cable (coaxial) ends in the "BUS 1" side of the digital repeater.
JP1
On
Resistencia final de línea.
JP1
Set to Off if does not end the video cable (coaxial) in the "BUS1" side of the digital
repeater.
Off
C
onfiguration of the repeater.
Use dip-switches Sw1, Sw2 and Sw3 to configure the repeater.

Dip-switch Sw2:

Depend on the type of units connected to the repeater and the function mode of the audio
separator (separator or separator with capacitance compensation of the audio line).
"Uno" units connected to input and output.
"Plus" units connected to input and output.
"Plus" units connected to input and "Uno" units connected to output.
Installation with "Plus" General door panels and "Uno" Inner door panels, configure
with this mode only the repeater of the first "Uno" Inner door panel.
"Plus" units connected to input and "Uno" units connected to output.
Installation with "Plus" General door panels and "Uno" Inner door panels, configure
with this mode the repeater of the next "Uno" Inner door panel.
"Uno" units connected to input and "Plus" units connected to output.
*
*Factory default
All manuals and user guides at all-guides.com
Placed to OFF , the repeater is configured as audio separator mode.
Set to ON, the repeater is configured as audio separator mode with
capacitance compensation of the audio line. (See configuration dip-
switches Sw1 and Sw3, page 34).
6
*Factory default
Continue