Advertisement
•
Keep the cable away from sharp edges or oil.
•
Use clamping devices or a vice to fix the workpiece.
•
Do not stoop down too far, firmly hold the device during work, and make sure to always keep
your balance. During work, ensure a safe footing and do not allow any diversion during work.
•
Use the appropriate tool for the proper application. A small grinder cannot be used for jobs that
you would need a large tool for. Only use this tool for jobs that is has been designed for.
•
Keep the device and your hands free from oil and dirt to ensure safe work.
•
Make sure that nobody is close to your work zone when you are working with the device.
•
Always wear suitable work clothing. Large clothes, jewellery, or long hair might get caught by
parts of the device.
•
For your own safety, it is recommended to wear protective glasses and gloves. With a great
amount of dust generated during work, you should wear a dust mask, too.
•
Always put the switch to the off position before connecting the device to the mains.
•
If using the device outdoors, make sure to only use extension cords suitable for outdoor use.
•
The device switched on must never be covered to prevent heat from accumulating.
•
Switch off the device and pull out the plug when the device is not in use.
•
Should the device be damaged, contact a specialised workshop. Do not try to repair the device
yourself if you are not qualified to do so.
•
The device may only be used by persons knowing the device and having read the manual.
•
Do not use the device when being tired or under the influence of alcohol, drugs, or medicine.
•
Do not work with the device near easily flammable matter, gases, or explosive atmospheres.
The motor of the grinder might generate sparks that could provoke an explosion.
Commissioning
•
Connect the desired accessory before plugging the plug in. Pull the power plug before changing
the accessory.
•
Fix the workpiece with a vice or a similar tool before beginning the work.
•
The rotation speed control on the rear side of the grinder must not be used during operation.
Only change the rotation speed with the grinder being switched off.
•
Use a low speed for applications as polishing, a high speed for drilling or cutting.
Changing the accessory
1.
Always make sure that the grinder is plugged off when changing the accessory.
2. Press down the locking knob on the front side of the grinder and untighten the tongs by turning
them anti-clockwise.
3. Place the clamping nut over the tongs, then place the desired accessory.
4. Re-tighten the clamping nut. To do so, do not use pliers, as these could damage the grinder.
Notes
•
Do not use the device for more than 10 min without interruption. Wait for the grinder to cool down
before re-using it.
•
Regularly lubricate the shaft of the device to ensure regular operation.
•
Do not apply excessive pressure onto the grinder during operation. Excessive pressure might
lead to inaccuracies.
•
To prevent the device from slipping off when drilling metal, you should use a punch to prepare
the drilling point.
•
Adapt the speed to the individual application.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 30297
Page 4
01
2022-1
Advertisement
