Connecting To A Pc - Samsung PPM42S2 Owner's Instructions Manual

Connecting to a PC

This PDP is not compatible with Macintosh PC.
PC (15pin)
BNC
Cable
Cable
Connecting a PC to the PDP
1 Connect a PC (15pin) or BNC cable between the Video Output jack on the PC and
the RGB1 (15p D-SUB) or RGB2 on the PDP.
• For an explanation of Component video, see your PC owner's instructions.
Connect a Audio cable between the Audio Output jack on the PC and the Audio Input (PC)
on the PDP.
2
To watch the PC screen:
1. Turn on PDP and press the RGB button on the remote to select the RGB mode.
2. Turn on PC and check for PC system requirements.
(Refer to pages 50 and 51 for PC system requirements.)
3. djust the PC screen. (Refer to page 52.)
48
Power Plug
Audio Cable
Pin Configuration
• 15Pin Signal Cable (based on protruded pin)
1 2 3 4 5
6 7 8 10
11 12 13 14 15
PC IN PC OUT
Pin No.
1 Red (R) Red (R)
2 Green (G) Green (G)
Blue (B) Blue (B)
3
4 Grounding Grounding
5 Grounding (DDC) Grounding (DDC)
Red (R) Grounding Red (R) Grounding
6
7 Green (G) Grounding Green (G) Grounding
8 Blue (B) Grounding Blue (B) Grounding
9 Reserved Reserved
Sync Grounding Sync Grounding
10
Grounding Grounding
11
12 Data (DDC) Data (DDC)
Horizontal sync. Horizontal sync.
13
Vertical sync. Vertical sync.
14
15 Clock (DDC) Clock (DDC)
Setting up Your Monitor (Plug and Play)
Our adoption of the new VESA Plug and Play solution eliminates complicated and time consuming
setup. It allows you to install your monitor in a Plug and Play compatible system, without the usual setup
hassles and confusion. Your PC system can easily identify and configure itself for use with your display.
This monitor automatically tells the PC system its Extended Display Identification data (EDID) using
Display Data Channel (DDC) protocols.
49