Indoor Wet & Dry Cleaning - PRIME AQUATIC 1400WB User Manuel

positioned on the opposite side to the suction hose plug-in connector hole
(7).
Push the plug-in connector on the suction hose (9) into the connection hole
(7) on the top of the collection tank and lock the connection by a half turn
to the right.
Connect the required number of suction tube extensions (10) to the suction
hose (9) and attach the suction nozzle (12) to the end of the suction tube
extensions (10).
Once the above has been completed, plug the device into the RCD. Place the
lance into the part of the pond to be cleaned. To start the motor, push the
switch (2) to position II AUTOMATIC.
After a working interval of approximately 30 seconds, the motor switches off
for approximately 30 seconds in order for the water to drain out of the
collection tank (8). During this time, you can reposition your lance in a
different part of the pond which requires cleaning.
The device will operate on this cycle until switched to the OFF position (0).
Always remove the plug from the RCD when the device is not in use.
Dirt and water should be thoroughly removed from the collection tank (8) at
the end of each use.
Indoor Wet & Dry Cleaning
Please proceed as follows when using the device for indoor wet and dry
cleaning:
Screw the drain hole cap (5) securely to the base of the collection tank over
the water discharge hole (8). This will create a vacuum inside the collection
tank.
For wet vacuuming, open the two locking clips (6) on the side of the
collection tank (8) and remove the motor head (1). Fit the filter sponge (13)
over the
motor head (1). Tighten the cord around the motor head. Place the motor
head back onto the collection tank, ensuring the locking clips are relocated
back into the corresponding indents on the collection tank, with the
electrical cable positioned on the opposite side to the suction hose plug-in
connector hole (7).
For dry vacuuming, open the two locking clips (6) on the side of the collection
tank (8) and remove the motor head (1). Attach the paper bag (16) to the
inside of the collection chamber over the hose plug-in connector hole
Prime Aquatic – info@prime-aquatic.com
9