Frontera KINGSLEY-BATE Assembly Instructions

ASSEMBLY INSTRUCTIONS FOR THE AM-15
BACK
RIGHT END FRAME
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match all joints with the corresponding letters
or numbers stamped on the furniture.
KINGSLEY–BATE
Fine Garden Furniture
LEFT END FRAME
STEP-II
Find the END FRAME with numbers stamped next to the mortise holes
and carefully lay it down. Matching the numbers, gently slide the BACK
STRETCHER, BOTTOM LEG STRETCHER and the SEAT into place. If
necessary, gently rock the parts while pushing the tenons into the mortise
holes until joints fit snugly together.
STEP-III
Carefully fit the remaining END FRAME mortise holes over and onto the
remaining SEAT,
STRETCHER tenons as shown in the assembly photo.
STEP-IV
Using a hammer, drive the dowels into the END FRAMES
to secure the SEAT and BOTTOM LEG STRETCHER. We
suggest that you use a block of wood between the hammer
and the dowel head for the last few blows. This will reduce
BACK STRETCHER
the chances of marring the wood.
SEAT
*NOTE:
A TENON
B MORTISE HOLE
and BOTTOM LEG