Baxi MANDO SILA RCV 300 Installation Instructions, Functioning And Maintenance page 20

ENGLISH
Caution:
!
this symbol indicates that care must
be taken to avoid damaging the appliance
• Do not make changes of any kind to the unit.
• Maintenance instructions must be followed to prevent damage to and/or
excessive wear of the device.
• Do not leave the device exposed to adverse weather conditions (rain, sun, etc.)
• Do not rest objects on the device.
• Internal cleaning of the product must only be carried out by qualified personnel.
• Periodically check device conditions. If imperfections are noted, do not use the
unit and immediately contact an authorised BAXI Technical Assistance Centre.
• Promptly contact an authorised BAXI Technical Assistance Centre in the event of
unit malfunction and/or failure and request the use of original BAXI spare parts
for any repairs.
• If the product falls or receives a strong blow, immediately have it inspected at an
authorised BAXI Technical Assistance Centre.
• The device must be installed so as to ensure that no one can come near its
moving or live parts during normal operating conditions.
• In the event of: device dismantling, using appropriate tools, heat exchanger
removal, motor module removal: the device must already be switched off and
disconnected from the electrical mains.
• The electrical system to which the product is connected must comply with
regulations in place.
• Only connect the device to the mains supply/ electrical outlet if plant/outlet
capacity is suitable for its maximum power. If otherwise, immediately seek
assistance from a professionally qualified person.
• Switch off the main switch on the system when: a malfunction is detected, you
decide to perform external cleaning maintenance, you decide not to use the
device for short or long periods.
• The extracted air flow must be clean (or rather free of grease, soot, chemical and
corrosive substances or explosive and flammable mixtures).
• Never cover the device intake and return to ensure optimal air passage.
• The electrical specifications correspond to the ones on the data label (Fig.A).
20
A
A