Subscribe to Our Youtube Channel
Related Manuals for Swegon TACtouch
Summary of Contents for Swegon TACtouch
- Page 1 OPERATION & ASSEMBLY MANUAL TACtouch CONTROL PANEL TO THE TAC5/TAC6 CONTROLLER 050371 - 20220503...
-
Page 2: Table Of Contents
XPLOITATION CONDITIONS ......... 5 SSEMBLY REQUIREMENTS ........6 ONTROL PANEL INSTALLATION ......7 ONNECTING OF THE CONTROL PANEL ....8 LEANING AND MAINTENANCE PROCEDURES CONNECTING TACTOUCH CONTROL PANEL TO THE TAC5/TAC6 CONTROLLER........9 LICENSES FOR OPEN SOURCE SOFTWARE ..13... -
Page 3: Safety
- important information, failure to observe these can cause damage of property, threat for human and household animal Assembly TACtouch has to be carried out by death and life. a qualified installer Caution: symbols... -
Page 4: General Information
6. General information The TACtouch control panel is designed to control the TAC5/TAC6 controller. Panel can be used in a household or similar environments slightly industrialized buildings. 7. Operation of the panel The device uses a screen with a touch panel. -
Page 5: Software Update
new software in a *.pfc format. New software should be copied directly to the memory card, not to a subfolder. Connect the electric power to the TAC5/TAC6 controller and open software update from main menu and replace the program in the control panel. 9. -
Page 6: Control Panel Installation
Manufacturer bears responsibility damages caused by non-observance of this manual. Control panel installation Possible methods of installation of the control panel on or in a wall. Drill a hole in the mounting plate acc. the below drawing or do it mounting the panel onto mounting screws with spacing indicated. -
Page 7: Connecting Of The Control Panel
Version 2: Connecting of the control panel The control panel should be installed with the mains supply disconnected from controller In additional, necessarily must insert the EMC filter, type ZCAT1518-0730 on the cable, as shown in the figure below. The EMC filter should The cable poles must be connected properly, be included with the controller. -
Page 8: Cleaning And Maintenance Procedures
In order to provide appropriate cooperation of It is not allowed to clean the device by the cable with a terminal, the length of not spraying water on it. If the water gets inside insulated ending of the cable and bushing tip of the device it can cause a fire or lead to should be within a range of 8÷10 mm. -
Page 9: Connecting Tactouch Control Panel To The Tac5/Tac6 Controller
10.Connecting TACtouch control panel to the TAC5/TAC6 controller... -
Page 13: Licenses For Open Source Software
11. Licenses for Open Source software Open Source Software used in the product. 1. zlib Copyright (C) 1995-2013 Jean-loup Gailly and Mark Adler Version 1.2.7 This software is provided 'as-is', without any express or implied warranty. In no event will the authors be held liable for any damages arising from the use of this software. Permission is granted to anyone to use this software for any purpose, including commercial applications, and to alter it and redistribute it freely, subject to the following restrictions: 1. - Page 14 3. sha2 LICENSE: Version This implementation is released freely under an open-source BSD license which appears at the top of each source code file. * AUTHOR: Aaron D. Gifford - http://www.aarongifford.com/ * Copyright (c) 2000-2001, Aaron D. Gifford * All rights reserved. * Redistribution and use in source and binary forms, with or without * modification, are permitted provided that the following conditions * are met:...
Need help?
Do you have a question about the TACtouch and is the answer not in the manual?
Questions and answers