Electrolux EW7W4858OB User Manual page 29

Table of Contents

Advertisement

3. If desired, set one or more options by
touching the related buttons. The
related indicators illuminate on the
display and the given information
changes accordingly.
If a selection is not possible
an acoustic signal sounds
and the display shows
.
12.6 Starting a programme
Touch the Inicio/Pausa
the programme. It is not possible to start
the programme when the indicator of the
button is off and doesn't flash (e.g. the
door is open).
The related indicator stops flashing and
stays on.
The programme starts, the door is
locked. The display shows the indicator
.
The drain pump can operate
shortly before the appliance
fills water.
12.7 Starting a programme with
the delay start
1. Touch the Inicio Diferido button
repeatedly until the display shows the
desired delay time. The related
indicator comes on.
2. Touch the Inicio/Pausa
The appliance door locks and starts
the countdown of the delay start. The
display shows the indicator
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start after
the countdown has started
To cancel the delay start:
1. Touch the Inicio/Pausa
pause the appliance. The related
indicator flashes.
2. Touch the Inicio Diferido button
repeatedly until the display shows .
3. Touch the Inicio/Pausa
again to start the programme
immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Inicio/Pausa
2. Touch the Inicio Diferido button
3. Touch the Inicio/Pausa
button to start
12.8 The SensiCare System
load detection
After touching the Inicio/Pausa
button, the SensiCare System starts the
laundry load detection:
1. The appliance detects the load in the
2. The programme duration will be
At the end of the load detection, in case
button.
of drum overload, the indicator
flashing in the display:
.
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Inicio/Pausa
the programme again. The SensiCare
phase can be repeated up to three times
(see point 1).
button to
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
button
pause the appliance. The related
indicator flashes.
repeatedly until the display shows the
desired delay time.
again to start the new countdown.
The programme duration in
the display is referred to a
medium/high load.
first 30 seconds. During this phase
the Time Manager bars
below the time digits play a simple
animation, the drum rotates shortly.
adjusted accordingly and could
increase or decrease. After further 30
seconds, the water filling starts.
ENGLISH
29
button to
button
placed
is
button to start

Advertisement

Table of Contents
loading

Table of Contents