Troubleshooting For Anynet - Samsung SYNCMASTER P2370HD User Manual

Troubleshooting for Anynet

¦
Problem
Anynet + does not work.
I want to start Anynet + .
I want to exit Anynet + .
The message Connecting
to Anynet + device...
appears on the screen.
The Anynet + device does
not play.
The connected device is
not displayed.
The TV program cannot
be recorded.
The TV sound is not
output through the
receiver.
+
Possible Solution
● Check if the device is an Anynet
supports Anynet + devices only.
● Connect only one receiver (home theater).
+ device power cord is properly connected.
● Check if the Anynet
+ device's Video/Audio/HDMI 1.3 cable
● Check the Anynet
connections.
● Check whether Anynet
Anynet + setup menu.
● Check whether the TV remote control is in TV mode.
● Check whether it is Anynet
+ doesn't work in certain situations. (Searching
● Anynet
channels, Operating, Plug & Play, etc.)
● When connecting or removing the HDMI 1.3 cable, please
make sure to search devices again or turn your TV off and on
again.
+ Function of Anynet + device is set on.
● Check if the Anynet
+ device is properly connected to the
● Check if the Anynet
TV and check if the Anynet + (HDMI-CEC) is set to On in the
Anynet + Setup menu.
● Press the TV button on the TV remote control to switch to TV.
Then press the TOOLS button to show the Anynet + menu and
select a menu you want.
● Select View TV in the Anynet
● Press the SOURCE button on the TV remote control and select
a device other than Anynet + devices.
● Press z, CH LIST, PRE-CH, and FAV.CH to change
the TV mode. (Note that the channel button operates only when
a tuner-embedded Anynet + device is not connected.)
● You cannot use the remote control when you are configuring
Anynet + or switching to a view mode.
● Use the remote control when the Anynet
to view mode is complete.
● You cannot use the play function when Plug & Play is in
progress.
● Check whether or not the device supports Anynet
● Check whether or not the HDMI 1.3 cable is properly
connected.
● Check whether Anynet
Anynet + setup menu.
+ devices again.
● Search Anynet
● You can connect an Anynet
only. Some Some HDMI cables may not support Anynet+
functions.
● If it is terminated by an abnormal situation such as
disconnecting the HDMI cable or power cord or a power failure,
please repeat the device scan.
● Check whether the antenna jack on the recording device is
properly connected.
● Connect the optical cable between TV and the receiver.
English - 32
+ device. The Anynet + system
+ (HDMI-CEC) is set to On in the
+ exclusive remote control.
+ menu.
+ setting or switching
+ (HDMI-CEC) is set to On in the
+ device using the HDMI 1.3 cable
+ functions.