Hyundai HG Series Manual page 9

Adjusting Settings
1. Enter Test Mode
˙ Stop the motor and verify that the amperage displayed on the
ammeter is 0.00 A.
˙ Press the TEST/RESET button to switch to test mode. Verify that
"TEST" is indicated on the display as shown.
2. Enter Password
˙ Press the "Set" button in test mode. Check if the four-digit
password input window appears on the indicator.
˙ Move to the next digit by pressing the "Set" button.
Use the and buttons to find the number of your choice.
˙ After entering all four digits, press the "Set" button. Make sure
to enter the right password to move on to the next menu item.
3. Enter Settings Menu
˙ Press the SET button while in test mode. Verify that the first
settings item is indicated on the display as shown.
4-1. M oving Between Settings Menus
(Using the SET Button)
※ This feature is useful for resetting all parameters on first use
after installation.
˙ Press the SET button when the first settings item is displayed.
Verify that the current settings are shown and flashing.
˙ Flashing indicates that the value can be changed.
˙ Use the , directional buttons to change the value. Check
the reference table for details on each settings value. Pressing
and holding the , buttons will accelerate the counter for
certain functions.
˙ Pressing the SET button while the desired value is flashing on
the display to confirm the relay's new settings.
˙ After setting the first item, verify that the second settings item is
displayed as shown.
Repeat the above process to adjust the settings as needed.
Electronic Motor Protection Relays
9