Advertisement
Holder connector
Clamp
ASSEMBLY of MOUNT & HOLDER
Attach the holder onto the holder connector.
HOLD YOUR DEVICE
Press clamp release button to
extend the clamp.
AIR VENT MOUNT
Clamp release button
360° Rotate ball joint
HOLDER
Phone Width Support : 50-105 mm
Clamp release button
Put your device onto the holder and
push the clamp back to secure your device.
NOTICE :
Before adjust the ball joint, please remove the
mount from the air vent.
Foldable buttom supports
NOTICE :
If the clamp touches VOLUME+/- or POWER
button, you can fold buttom supports to adjust
your phone position in holder.
Slide down the holder to secure.
Advertisement
Table of Contents
Related Manuals for ikross IKHD74
Summary of Contents for ikross IKHD74
- Page 1 AIR VENT MOUNT Clamp release button Holder connector NOTICE : Before adjust the ball joint, please remove the 360° Rotate ball joint mount from the air vent. HOLDER Phone Width Support : 50-105 mm Foldable buttom supports NOTICE : If the clamp touches VOLUME+/- or POWER button, you can fold buttom supports to adjust Clamp Clamp release button...
- Page 2 Car Air Vent Mount Holder for Smartphone USER’S MANUAL IKHD74 INSTALLATION Press & hold the clamp release button and install the mount onto the air vent then release the button to secure. NOTE : Recommend to install the mount on the bottom of the air vent.
Need help?
Do you have a question about the IKHD74 and is the answer not in the manual?
Questions and answers