Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Diamond SFE12/D-N
Summary of Contents for Diamond SFE12/D-N
- Page 1 04/2013 Mod: SFE12/D-N Production code: UH-12 & IL-1...
-
Page 2: Table Of Contents
CONTENT Declaration of a standart confirmity Technical data Packing check and important indication Instalation Placement of the device Chart Connection of the electric cable to electricity Maintenance Instructions for use Cleaning and maintenance Process in case of wrong function of the device Wiring diagram: UH-12 Wiring diagram: IL-1... -
Page 3: Declaration Of A Standart Confirmity
DECLARATION OF A STANDARDS CONFORMITY The producer confirms that the devices agree with CEE 90/396 standards,rule nr. 22/1997 sb. and with relevant goverment orders. Instalation must be done with respect to valid standards. Attention, the producer refuses any responsibility in case of direct or indirect damages which are caused due to wrong instalation, incorrect intervention or modification, insufficient maintenance, incorrect use and also possibly caused by other reasons presented by items in sale conditions. -
Page 4: Packing Check And Important Indication
PACKING AND DEVICE CHECK The device leaves our stocks properly packed with appropriate symbols and labels. There are also appropriate instructions for use. In case the packing shows bad handling or damage, it must be reclaimed at transporter immediately by writing and signing of a damage protocol. Important notice: •... -
Page 5: Chart
Wrap up the device and check whether it was not damaged during transport. Settle the device on horizontal surface (max imbalance 2°).Settle the device under the fumehood to eliminate water steam and bad smell.The device can be instalated separately or in a set with devices of our production. -
Page 6: Connection Of The Electric Cable To Electricity
CONNECTION OF THE ELECTRIC CABLE TO THE ELECTRICITY Instalation of electric feeder - This feeder must be separetely protectedby a safety fuse according to the specific electric stream which depends on the wattage of the instaled device. Check the wattage on the label atthe back of the device. Connect the device directly to the electricity but you must put the switch between the device and electric net. -
Page 7: Cleaning And Maintenance
CLEANING AND MAINTENANCE ATTENTION! The device cannot be cleaned by direct or pressure water.Clean it daily. Daily maintenance keeps longer useful life and efficiency ofthe device. Before cleaning make sure to have disconnected the device from electricity. Always switch off the main feeder to the device. -
Page 8: Wiring Diagram: Uh-12
WIRING DIAGRAM: UH-12 1.- Terminal board 2 – Main switch 3 – Green control light 4 - Thermostat 5 – Orange control light 6 - Heating element... -
Page 9: Wiring Diagram
WIRING DIAGRAM: IL -1 1.- Terminal board 2 – Main switch 3 – Green control light 4—Heating element...
Need help?
Do you have a question about the SFE12/D-N and is the answer not in the manual?
Questions and answers