Table of Contents
Advertisement
Quick Links
Roverpet
20 Kiji Dava Circle Prescott, Arizona 86301
Roverpet #44PR – 4' x 4' Puppy Rail Assembly Instructions
Inventory List for The Roverpet #44PR Puppy Rail System:
(2) #PR48LB 48" Long Support Bar
(4) 2", 3", 4", 5", 6" or 8" high legs (depending on style of Roverpet Puppy Rail System ordered)
Assembly Procedure
Special Notes: If the Roverpet 4'x4' whelping box consists of a door panel, it needs to be configured with the door located on
Assembly of the Roverpet Puppy Rail System needs to be done outside of your existing Roverpet whelping box, than installed
1.) Unpack contents of shipping carton and compare to inventory list above.
2.) Install all (4) legs of the Roverpet Puppy Rail System into the 4 small leg hole locations on both #PR48LB.
800-658-5925
(2) #48CB 48" Long Crossbar and
the right to allow door hinge clearance.
into the whelping box once fully assembled.
rover@roverpet.com
Page 1 of 3
Advertisement
Table of Contents
Related Manuals for Roverpet 44PR
Summary of Contents for Roverpet 44PR
- Page 1 (4) 2”, 3”, 4”, 5”, 6” or 8” high legs (depending on style of Roverpet Puppy Rail System ordered) Assembly Procedure Special Notes: If the Roverpet 4’x4’ whelping box consists of a door panel, it needs to be configured with the door located on the right to allow door hinge clearance.
- Page 2 6.) Clip the #PR48LB connecting ends around the vertical bars. 7.) With the one side of the #PR48LB installed on the vertical bars, slide the high-side of the Roverpet Puppy Rail System down into the Roverpet whelping box. Make sure the #PR48LB connecting ends are installed in the same manner as in the prior step.
- Page 3 8.) Push the whole Roverpet Puppy Rail System down until all four legs are resting on the Roverpet whelping box floor. Note: Pig Rails can reduce the risk of possible suffocation. Note: Puppies should be watched at all times when small.
Need help?
Do you have a question about the 44PR and is the answer not in the manual?
Questions and answers