Advertisement
MAINTENANCE:
1.
For best performance, maintenance should be carried out once every 3 to 5 weeks,
depending on water conditions.
2.
To achieve maximum efficiency, the filter cartridge should be replaced every month.
Do not use detergents to clean the aquarium, its components or filtration materials.
3.
Always unplug the adaptor and disconnect before carrying
4.
out maintenance.
Take out stone stacking ornament.
5.
6.
Replace the filter cartridge (refer to "Replacement parts
and accessories" at the end of this
manual), rinse the filtercartridge with water taken
from the aquarium. (Ref. Fig. 6).
Rinse the stone stacking ornament under running water.
7.
To avoid damages/scratches to the aquarium, use SOFT
8.
WOOL/CLOTH material for cleaning.
9.
When changing water, only change 25% of the water and
re-fill the tank with tap water. Remember to add Chlorine Neutral!
10. AA recommends cleaning the impeller of the pump once
every 6 months to ensure smooth and reliable performance.
i)Remove the pump from the stone stacking ornament.
Ref.to Fig. 7a Remove the filter cartridge from the pump.
ii)Slightly bend the front cover; the impeller
housing will be disassembled from the pump.
(Ref. To Fig. 7b)
iii) Remove the impeller assembly to
clean / brush under running water.
iv)Re-assemble the pump, filter
cartridge & the stone stacking ornament.
LAMP MAINTENANCE TIPS
Q.
My Deco O tank worked well, but recently the light doesn't seem to be working properly. It
seems like the touch function is no longer working.
A.
You can first try to reset the electronics by unplugging the USB plug between the lighting and
the USB adapter. Re-connect after 10 seconds to see if it works.
Sometimes there could be some water droplets or algae growth around the silicone o-ring
between the sensor of the Uni-Module and the top plate, which may affect the sensor.
1.
Unplug the USB of the LED light. Remove the cover from aquarium, carefully line up the pivot
with the slot. Gently lift it from the pivot side of the plate (Ref. Fig.8A).
2.
Unscrew. (Ref. Fig.8B)
Gently lift the Uni-Module and clean with a damp cloth. (Ref. Fig.8C)
3.
* Note: you can re-connect the USB plug to see if the Uni-Module works. If it is still faulty,
please contact our servicing agent for replacement.
4. Pay attention to the silicone o-ring and the square area within the o-ring. Clean
o-ring to remove any algae or water droplets. Dry with a paper towel before re-assembling
(Ref. Fig.8D).
Fig. 8a
If the light still not function properly, please replace a new one. (Replacement LED model no.
refer to "Spare Part table" at the end of this manual)
Fig. 7b
Fig. 8b
Fig. 6
Fig. 7a
this area & the
Fig. 8c
Fig. 8d
Advertisement
